Hoping to install the A.N. big brake kit, and new pads tonight and the kuryakyn breather bolts that should come in today to vent the intake.

 

Outstanding Tall Timber!

Edit: received the new clutch cable, might run it alongside the old one to get an idea how it is going to work. Maybe later-I don't feel like doin' crap right now.

Edit: it looks like the clutch cable will work, but the real test is to actually install it.

 

Thanks mate!

Took 3 bleeds and that was with plugging the ABS into the computer and "Agitating" it. My indy did it, I don't touch ABS.

 

Changed the oil with some Mobil 1 and a new set of plugs.

 

Memphis Shades "Memphis Fats" installed on the Fat Bob. I doubt it will see very much road time, but thought it would be nice to have for a trip.

 

I screwed two pieces of 1 x 6 lumber to the floor and pulled the bike up on those so it would lean over more and hopefully not lose as much transmission fluid when taking the clutch release cover off. A little came out as you can see.

 

Called the powdercoaters and made a small change so they could get the caliper to me on Moday. I had wanted some special masking but they were resisting. F'k it. I'll work around it.

Pete, from Rocket Bob's, called me to discuss my seat pan. He's super slammed prepping for a show so he won't be able to get the seat done until October. Fine by me.

 

Hey, maybe I missed it, but did you ever get the NIX30 carts from Howard?

As to what I did today, I finally swapped my LRS bobbed fender for a full rear with a GBG sig/plate relocator and a CD LED tail light. Of course no photos...

 

Not yet. I told him to take his time, tho. He's been really busy and I'm not in a huge hurry.

 

Going back out in a bit to clean up these parts and re-assemble.