What did you do to your Dyna today?
#7261
Hoping to install the A.N. big brake kit, and new pads tonight and the kuryakyn breather bolts that should come in today to vent the intake.
#7262
Join Date: Jan 2014
Location: Depends on who wants to know.........and why.
Posts: 8,688
Received 1,902 Likes
on
1,109 Posts
Outstanding Tall Timber!
Edit: received the new clutch cable, might run it alongside the old one to get an idea how it is going to work. Maybe later-I don't feel like doin' crap right now.
Edit: it looks like the clutch cable will work, but the real test is to actually install it.
Edit: received the new clutch cable, might run it alongside the old one to get an idea how it is going to work. Maybe later-I don't feel like doin' crap right now.
Edit: it looks like the clutch cable will work, but the real test is to actually install it.
Last edited by SixDD; 08-11-2017 at 07:24 PM.
The following users liked this post:
Tall Timber (08-12-2017)
#7263
Join Date: Aug 2012
Location: Yarra Ranges, Victoria, Australia
Posts: 1,363
Received 425 Likes
on
259 Posts
Took 3 bleeds and that was with plugging the ABS into the computer and "Agitating" it. My indy did it, I don't touch ABS.
Last edited by Tall Timber; 08-11-2017 at 06:36 PM.
The following users liked this post:
cvaria (08-11-2017)
#7265
Memphis Shades "Memphis Fats" installed on the Fat Bob. I doubt it will see very much road time, but thought it would be nice to have for a trip.
#7266
Join Date: Jan 2014
Location: Depends on who wants to know.........and why.
Posts: 8,688
Received 1,902 Likes
on
1,109 Posts
I screwed two pieces of 1 x 6 lumber to the floor and pulled the bike up on those so it would lean over more and hopefully not lose as much transmission fluid when taking the clutch release cover off. A little came out as you can see.
#7267
Called the powdercoaters and made a small change so they could get the caliper to me on Moday. I had wanted some special masking but they were resisting. F'k it. I'll work around it.
Pete, from Rocket Bob's, called me to discuss my seat pan. He's super slammed prepping for a show so he won't be able to get the seat done until October. Fine by me.
Pete, from Rocket Bob's, called me to discuss my seat pan. He's super slammed prepping for a show so he won't be able to get the seat done until October. Fine by me.
#7268
Called the powdercoaters and made a small change so they could get the caliper to me on Moday. I had wanted some special masking but they were resisting. F'k it. I'll work around it.
Pete, from Rocket Bob's, called me to discuss my seat pan. He's super slammed prepping for a show so he won't be able to get the seat done until October. Fine by me.
Pete, from Rocket Bob's, called me to discuss my seat pan. He's super slammed prepping for a show so he won't be able to get the seat done until October. Fine by me.
As to what I did today, I finally swapped my LRS bobbed fender for a full rear with a GBG sig/plate relocator and a CD LED tail light. Of course no photos...
The following users liked this post:
Mchad (08-11-2017)
#7270
Join Date: Jan 2014
Location: Depends on who wants to know.........and why.
Posts: 8,688
Received 1,902 Likes
on
1,109 Posts