What did you do to your Dyna today?
#3143
Another hot day not as bad as yesterday. Sundowner feeling better the 2nd day!! ALOT of bikes out today !!
Gotta start carrying can of shield cleaner & micro rag, freakin bugs :-0 Don't know how you guys that don't wear FF or shield tolerate them???
Stay Safe!!!!!!!!!!!
Gotta start carrying can of shield cleaner & micro rag, freakin bugs :-0 Don't know how you guys that don't wear FF or shield tolerate them???
Stay Safe!!!!!!!!!!!
Last edited by KSJ08; 07-17-2016 at 04:14 PM.
#3144
Fiddled with front brakes. Disassembled, dropped some bolts in parts cleaner. General cleaning of brake parts. Checked to see if the rotor is centered in the brake caliper and it is - bravo!
Damn it is humid/hot in my shop! Even with the AC full blast I can barely stand it out there. I must finish the insulation this fall!
Damn it is humid/hot in my shop! Even with the AC full blast I can barely stand it out there. I must finish the insulation this fall!
#3145
Adjusted the clutch pack and the clutch cable freeplay again today; I completely blew it yesterday when I did the clutch pack and cable freeplay adjustments. I think I got a false stop on the clutch pushrod screw yesterday; that adjustment was just bad, the clutch plate drag was horrid; completely my fault, and the bike was very unhappy.
Today I ran the clutch pushrod screw in an out to clean any possible burrs off the screw; readjusted and took her for a ride. Flawless upshifting and rev matched downshifting once again, had to have been a burr on the pushrod screw to throw off the light seat. I was even sober when I did that adjustment yesterday... that'll teach me, I'll know better next time...
Today I ran the clutch pushrod screw in an out to clean any possible burrs off the screw; readjusted and took her for a ride. Flawless upshifting and rev matched downshifting once again, had to have been a burr on the pushrod screw to throw off the light seat. I was even sober when I did that adjustment yesterday... that'll teach me, I'll know better next time...
#3146
Installed "Wards" fans. Only did a short test ride, but it was hot and humid here as always and temp was holding well with the fans on (using Power Vision to measure temp).
Looking forward to some long rides to get a real good sense of what the results will be.
Looking forward to some long rides to get a real good sense of what the results will be.