What did you do to your Dyna today?
The following users liked this post:
antlockyer (04-28-2016)
#2393
Join Date: Jan 2014
Location: Depends on who wants to know.........and why.
Posts: 8,688
Received 1,902 Likes
on
1,109 Posts
I just wrote to purpose built and asked them if they sell them without the logo. I'll let you know what they say.
I like the linkage, just not with that big logo.
Bike looks great East Coast Dyna Mike!
I like the linkage, just not with that big logo.
Bike looks great East Coast Dyna Mike!
#2394
Sounds good thanks. I'm with you on the logo thing. Some of these guys make great stuff then jam the logo all over it.
#2397
No, both sides of the linkage do not have their logo. The logo side is flat, the side that doesn't have the logo is convex. I was a little hesitant which side to face out as well. But figured I'd leave it out for now. Side note, they don't come with the bolts to bolt it on so I had to pick up some stainless one's from the hardware store, no biggie, just a few bucks.
Edit: I will also say, this thing is super beefy, very happy with it.
Edit: I will also say, this thing is super beefy, very happy with it.
Last edited by East_Coast_Dyna_Mike; 04-26-2016 at 02:32 PM.
#2398
Join Date: Sep 2012
Location: Tallahassee, Florida
Posts: 12,363
Received 2,199 Likes
on
1,685 Posts
Right side big brake (06+ dyna, AN-02-973) kit ordered.
props to Phat Performance for getting the kit for me at a monster discount from direct from Ness.
http://www.phatperformanceparts.com/...earch.y=0&mfg=
props to Phat Performance for getting the kit for me at a monster discount from direct from Ness.
http://www.phatperformanceparts.com/...earch.y=0&mfg=
#2400
I used my metal cutting disk from my Dremel and put it on my drill. Keep the cutting device on the side of the shield you are cutting off though to prevent damaging the part you are keeping.