What did you do to your Dyna today?
Changed engine oil n filter.
1st oil change since I've owned it (6,000 miles). And did it need it !
A gorilla must have put the filter on.
I thought I was gonna crush it before it broke free (strap wrench)
For the life of me, I can't figure why folks believe that " if tight is good. Tighter is better".
Never installed a filter more than hand tight, and never had one leak or back off.
Settled on Lucas 20w/50 dino.
O ring looked fine on the drain plug, didn't see the need to replace it. No metal shavings that I could see on the magnet.
Life is good..
1st oil change since I've owned it (6,000 miles). And did it need it !
A gorilla must have put the filter on.
I thought I was gonna crush it before it broke free (strap wrench)
For the life of me, I can't figure why folks believe that " if tight is good. Tighter is better".
Never installed a filter more than hand tight, and never had one leak or back off.
Settled on Lucas 20w/50 dino.
O ring looked fine on the drain plug, didn't see the need to replace it. No metal shavings that I could see on the magnet.
Life is good..
Last edited by KentuckyChristian; 07-31-2023 at 06:35 PM.
Had viking... The quick release brackets broke after a few years... Went with leatherpros... Really like these bags they fit more snug.
Test fit the new short front fender - it will be raised up to 1/4 - 3/16 inch clearance. I ordered some new stainless steel hardware for it.
Last edited by NeverDone; 07-31-2023 at 07:20 PM.
The following 2 users liked this post by NeverDone:
KentuckyChristian (08-01-2023),
Von Gruff (07-31-2023)
Drilling holes in the full fender today. I'm going with the full fender (stock fender) yet I'm lowering it closer to the tire.
The following users liked this post:
StanC (08-03-2023)
i bought a 2013 Street Bob a few days ago that had a Bassani 2-1, a nice looking exhaust but didn´t sound the way i like so a supertrapp vent on the Bassani headers, the fittment was allright but it left a gap that the Bassani heatshield couldn´t cover so i did a littel hammering and bending to fix that, was hoping to get a good long ride today but the weather suggested a day in the garage intstead
The following 3 users liked this post by jyx:
i bought a 2013 Street Bob a few days ago that had a Bassani 2-1, a nice looking exhaust but didn´t sound the way i like so a supertrapp vent on the Bassani headers, the fittment was allright but it left a gap that the Bassani heatshield couldn´t cover so i did a littel hammering and bending to fix that, was hoping to get a good long ride today but the weather suggested a day in the garage intstead
The following users liked this post:
jyx (08-04-2023)
I have to install it, but bought a tuner and air cleaner from fuel moto for birthday present to myself lol
The following 2 users liked this post by Paintslinger16:
98hotrodfatboy (08-04-2023),
Garage Queen Rescue (08-04-2023)
Not today but I recently did an iron butt challenge. Solo. 1500KM in 15 hrs 40 min. Lots of breaks. The bike ran perfectly all day. I was deaf and wet at the end of it.
The following 10 users liked this post by underwhelmd:
98hotrodfatboy (08-06-2023),
Blue Bob (08-05-2023),
Dynawobble (08-08-2023),
Garage Queen Rescue (08-06-2023),
Jed Clampett (08-09-2023),
and 5 others liked this post.