Made my own pelican 1430 bags this off season. I have to say, they are ****ing mint!

Leaned out!

I have to say, I'm dam proud! @ 42, retired Vet, now qual welder! Working in vintage bike shop. She is my first HD, and bike. Rebuild the top end and carb this winter!

Made my bags, crash bar, sissy bar and mounts. I have done everything and then some! 2500km (🇨&#127462 and going on the fresh engine.

 

Tall, hope all goes well medically. Ribs and rotator cuff I know about and that is some serious pain but the mass I hope is benign and either way can be completely removed. Keep up the good fight! The alternative sucks.

 

Spent the last couple of days after work installing the JD Customs FXRT fairing. This thing is effing sweet. Gonna ride it around primered for a bit while I find someone to get it painted and then get all the wiring situated.

 

Just gave it a wash and wax.....

 

Installed this Oil Pressure Gauge from Mid USA. Took about 10 minutes and works a treat.

 

I dropped almost $300 on arp fasteners. Man they look sweet.

 

12pt type? I think I might switch all mine to those. I'm tired of stripping Torx heads even when I have the right damn size bit!

 

Yeah man. It took some time to figure out everything I needed but it’ll be worth it in the end. Between Jegs and Summit Racing they had everything..... there’s a few places that sell “kits”, like IMZZ, but they are marked up astronomically high. You can definitely save some bucks if you source them yourself.

 

I gave my Dyna company in the garage. Say hello to a 2020 FLTRK!

 

Wearing the last few kilometres off the bridgestone front tire in Annapolis Valley, Nova Scotia. It's being switched to a Metzeler 888 tomorrow to match the rear. 7000Km seat time so far.