I believe so. I bought them here on the parts section of the forum. seller took a picture with a tape measure and they looked closer to 4.5" according to messages back and forth but can't find picture to double check.

 

Getting her cleaned up after work.

 

Put new windscreen on. Weather in S. CA is perfect and took 300 mile ride. Now taking windscreen off to be painted same color as the bike.

 

My bad back decided to go out as soon as I got out of bed this morning so it has been very slow going but I managed to get the relocation accomplished! This did not go near as easily as planned since I found the wires under the fender had been mangled and spliced by the PO or a mechanic when the Harley QD system had been installed with the blinkers on the end on it. Bare wires wrapped in tape and several butt slices had to be addressed the correct way!
Tomorrow the plan at least is to get the Viking quick detach system installed along with the Harley QD system.

 

Took the front end off to grease the steering head bearings and paint the lowers and triple trees.

 

I'm planning that same job for sometime after the snow flies. Interested to see your results. I'm back and forth on painting the trips.

 

Epoxy painted the battery cover, electrics cover, and mirrors. Drying in a heated room now.

 

I will be riding through most of the winter but since it is raining all weekend with lots of flooding it is the perfect time to do it. I will post pics when I'm done.

 

Changed the fluids in all 3 holes and adjusted the clutch. Also, removed the CA EPA compliant charcoal canister and all the tubes/lines that attach to it.





For off road use only, of course...

 

Took some doing but got the Viking QD bag hardware installed along with the Harley QD stuff. Viking bolts are either way too long or way too short and have to be cut to proper length. Also the kit they sent me had 2 of the mounting bungs with too small an internal diameter to go over the bolts. Ended up drilling them out instead of calling and waiting on them to send me 2 more of the proper size. Nearly an inch deep of drilling was require but got it done. Luckily the steel they use is not the best quality in this case! I will eventually change this stuff out for something more esthetically pleasing. Just happy to finally be able to mount some large bags on this bike a little latter on!