1983 FXDG Refurbish Thread
#81
Hey Troy, here is a pic of the medallion with dimensions if you need it. 2.125 inch wide by .6875 inch tall. Brass.
I have the hole in my fender for the medallion.
The hole is this size.
Any chance your friend can make 2 medallions? If yes, How much do you think it would cost?
Thanks
I have the hole in my fender for the medallion.
The hole is this size.
Any chance your friend can make 2 medallions? If yes, How much do you think it would cost?
Thanks
#84
#85
Hi mrlexus i am going to instal the fender medallion on today first aim going to use an other fender to slightly bend the pin then put it on my FXWG , ill be sure to post a picture of it when iam done. the threads on the back are 5mm, so my hole in the fender will be a little more than double the size of the original hole, i am not sure how the original medallion was secured but with such a small hole ( 2.1mm ) i think it has just a post on the back and it was secured with a speed nut.
#86
Ok folks , goter DONE !!! such a simpel thing, but un the end its all the little details that make the FXDG such a cool bike, thanks to mrlexus for the photos, shovhd for the measurements on the placement and to my Friend Armin for making the reproduction of the Medallion...
Re-po Fender Medallion , any one needing one can PM , and ill see what we can work out !!
#88
oh no, I've still got a lot of work to do just getting to the small stuff while i am waiting on the motor, i sent out the exhaust for coating and when thats done i can put the primary together then the oil tank and lines i still need to think about the primary drive too. ill be sure to post pics as i go...
#89