120r Turbo
#41
Minnesota
Heat is what you get when you drive a harley in a parade... I don't do that... When it's 90 plus, and you run hard, the next stop light can be a little warm, yet not bad that that you wish you were driving something much less.....Fire up the tunes, light the cigar, and who cares about the heat.... by the way very few days we have 90 plus....
#42
You would have been just fine with a 2 bar map sensor from Zippers. You dont need a 2.5. Why did you think you need a 2.5? It does not sound like you are multi stages of boost.
Is Trask doing the crank and changing the rods?
We are getting ready to re-do a 110 with a trask next week to bump up the power.......
Good luck cant wait to see the post......
Is Trask doing the crank and changing the rods?
We are getting ready to re-do a 110 with a trask next week to bump up the power.......
Good luck cant wait to see the post......
Ran stock compression... Motor all stock.... no issues... moved up to 130 inch will run higher compression again... I was looking for a 2.5 bar... did not find one... will keep boost to 9 with 92 and 15 or less with better fuel.... Trask is doing the work... expecting small improvement in performance...... The engine
much like the 103 inch two years ago, the combination on both bike have been bullet proof.... will share new power curve values when complete end of month..
much like the 103 inch two years ago, the combination on both bike have been bullet proof.... will share new power curve values when complete end of month..
Last edited by DRAGO'S BIKE WORKS; 02-06-2012 at 07:39 AM.
#43
#44
You push any more than 15/16 lbs those cylinders wont handle it you will blow the studs right out....... Be..care..full.. They know better than than that......... We have are own cylinders that will handle up to 30 lbs boost.
But the HD cases will not handle it. We have found the Jims cases work best....... Big and Beefy.......
Good luck....
But the HD cases will not handle it. We have found the Jims cases work best....... Big and Beefy.......
Good luck....
#49
Steve I have nothing to do with this bike. He is just asking for info. I think he lives in Minn. He had the bike or motor shipped to Trask from what I understand.
You know me I dont need Trask to do anything for me. I am re-doing a Trask system next week on a built 110 cvo. Not making enuff power for customer he is not happy.
You know me I dont need Trask to do anything for me. I am re-doing a Trask system next week on a built 110 cvo. Not making enuff power for customer he is not happy.
#50