ok I used the barrel style fuse holders. How did you run your cables to the battery? You know there's a channel....the frame is hollow down bth sides unter the tank. Each end is open and you can run your power and ground cables through that frame and it comes out right at your battery. No need to take the tank off. Then what I did was stuffed that barrel fuse holder back into the end of the frame, so its out of the way.
There is a small slot on either side of the frame up in the neck area. I ran a hanger from the front of the bike, with the outer fairing off, between the forks, through the slot in the frame, through the frame, and out right by the battery. Tapped wires to the hanger, and pulled them through the frame. I have 4 gauge power and ground on one side of the frame, and 4 sets of speaker wires run through the other side of the frame.
Yeah, I removed the tank and and pulled the 4-ga power line out of the wire track, and then ran it up the left side tube path, I put some convoluted plastic tubing over the wire to prevent possible chaffing.
I used the Stinger waterproof, dustproof Fuse Holder and it fits in print of the battery, you connect the 4-ga with a ferrule to the Fuse holder and it can use Mini ATL or Dual ATC fuse
11-09-2021, 11:29 PM
