Audio Install 2020SGS
#31
DAY NINE:
Thought I was done with the front end, So I went to put faring on just to check fitment one last time, and it didn't fit. My intent was to keep all the OEM wiring and connections in place, but I may have to cut some of them out to make room.
I am not sure how you guys are putting more than two amps and a DSP in these street glides. And from what I hear the Road Glides have even less room. I have looked for photos, but most focus on the goodies and not the wiring beyond.
I spent some time troubleshooting and seeing where to conflicts were, and i think I see where I got issues, now I got to figure out how to reroute it all.
Thought I was done with the front end, So I went to put faring on just to check fitment one last time, and it didn't fit. My intent was to keep all the OEM wiring and connections in place, but I may have to cut some of them out to make room.
I am not sure how you guys are putting more than two amps and a DSP in these street glides. And from what I hear the Road Glides have even less room. I have looked for photos, but most focus on the goodies and not the wiring beyond.
I spent some time troubleshooting and seeing where to conflicts were, and i think I see where I got issues, now I got to figure out how to reroute it all.
#32
#34
The 2400 is the same size as a pair of 800's., maybe a little less wire running at the amp. I have plenty of room on the amp rack. It's below that that I am having issues. I don't really have a better spot for the DSP either. I am thinking I just need to cut off all the OEM speaker wiring that is not needed, and the extra pieces from the AHB T-Harness I am using.
#37
#38
#39
No. Its all the cabling running in leaving the amp and all the stock wiring. It is hitting the fairing at the top of the headlight.
#40