Ground for Amp
#1
Ground for Amp
Another Stupid Question of the Day!!!!!
My Boss amp kit had an 4' ground. Not enough to run to the battery of my 2014 Ultra.
where does one place an Amp ground within the fairing? Speaker pod/Amp tray screws? Use power wire or purchase a 6' line instead?
who gives 16' of red power wire and 4' of ground wire....JEEZ!!!
My Boss amp kit had an 4' ground. Not enough to run to the battery of my 2014 Ultra.
where does one place an Amp ground within the fairing? Speaker pod/Amp tray screws? Use power wire or purchase a 6' line instead?
who gives 16' of red power wire and 4' of ground wire....JEEZ!!!
#2
These kits are for car installation. Normally you run the the to battery take tank off to run OFC 8 ga power and ground to battery or ground to frame where the battery is grounded at.
You will need to remove the battery to get to that ground bolt
even run a 4 or 0 ga ground from battery to that factory ground bolt. Don't know what wattage your amp is though.
You will need to remove the battery to get to that ground bolt
even run a 4 or 0 ga ground from battery to that factory ground bolt. Don't know what wattage your amp is though.
#4
The following 2 users liked this post by chopper_man:
FLHTK2015 (06-11-2021),
jester0618 (06-11-2021)
#5
Another Stupid Question of the Day!!!!!
My Boss amp kit had an 4' ground. Not enough to run to the battery of my 2014 Ultra.
where does one place an Amp ground within the fairing? Speaker pod/Amp tray screws? Use power wire or purchase a 6' line instead?
who gives 16' of red power wire and 4' of ground wire....JEEZ!!!
My Boss amp kit had an 4' ground. Not enough to run to the battery of my 2014 Ultra.
where does one place an Amp ground within the fairing? Speaker pod/Amp tray screws? Use power wire or purchase a 6' line instead?
who gives 16' of red power wire and 4' of ground wire....JEEZ!!!
#6
Originally Posted by qclassic
These kits are for car installation. Normally you run the the to battery take tank off to run OFC 8 ga power and ground to battery or ground to frame where the battery is grounded at.
You will need to remove the battery to get to that ground bolt
even run a 4 or 0 ga ground from battery to that factory ground bolt. Don't know what wattage your amp is though.
You will need to remove the battery to get to that ground bolt
even run a 4 or 0 ga ground from battery to that factory ground bolt. Don't know what wattage your amp is though.
Or just ground directly to the battery.
T
Trending Topics
#8
#9