Mmats set up
#1
04-03-2019, 01:24 PM
Mmats set up
I am new to the stereo set up world. I have a Kenwood Deck KRC-X998 that has a built in DSP (basic) and EQ. Running through a SS PN4.1000d. I have channels one and two running WDX6moto's that sound good DSP 90hz and slope 18. that toned the highs and sound alot fuller. Now I am adding Mmat 601.4 to the mix channels 3-4, I can limit the low end with the deck but I cant limit the highs. The web site states 12hz-5000hz, do I need to be concerned with capping the high with a crossover or something? sorry if this is a stupid question. Thanks !
Last edited by Fireball Jack; 04-03-2019 at 01:26 PM.
#2
04-03-2019, 02:59 PM
Originally Posted by Fireball Jack
I am new to the stereo set up world. I have a Kenwood Deck KRC-X998 that has a built in DSP (basic) and EQ. Running through a SS PN4.1000d. I have channels one and two running WDX6moto's that sound good DSP 90hz and slope 18. that toned the highs and sound alot fuller. Now I am adding Mmat 601.4 to the mix channels 3-4, I can limit the low end with the deck but I cant limit the highs. The web site states 12hz-5000hz, do I need to be concerned with capping the high with a crossover or something? sorry if this is a stupid question. Thanks !
T
#3
04-03-2019, 03:23 PM
A tad bit late for that I have them already. They will be going in the lowers. In the tour pak I have kappa 62.11 run off of another amp. So what can I do to get some mid bass from the Mmat 601.4
Thread
Thread Starter
Forum
Replies
Last Post
RickK
Audio Systems
0
04-29-2018 08:40 PM