2017 Road Glide stereo sounds different when running
#11
#12
#13
#14
Talked to JL before using this amp with my set up, they said I shouldn't have any problems, and haven't had any problems the last 6 months I've been using it. The new edition is the PSM, trying to clean it up a little. Otherwise it sounds good, of course after many speaker changes before I got to where I'm at now.
#15
Originally Posted by arlington
Talked to JL before using this amp with my set up, they said I shouldn't have any problems, and haven't had any problems the last 6 months I've been using it. The new edition is the PSM, trying to clean it up a little. Otherwise it sounds good, of course after many speaker changes before I got to where I'm at now.
I just don't think I would set a system up with 70W x 4 @ 4 ohm - 14.4 volts on a sled. If u roll parallel 4 ohm speaks to 2 ohm load ur looking at 62.5 watts each. If ur running all high efficient PAs u might me ok as the JL shix is damn efficient but I think ur leaving a bit on the table with that amp powering ur setup.
Like I said, if it works for ur ears roll with it but just throwing out some different perspectives.
T.
The following users liked this post:
arlington (05-19-2018)
#16
Yeah, its actually pretty loud and clear, been told by a few shops local that I should get a small two channel amp and run the B3s on. But after talking to two different JL techs they said I should be fine running six speakers.Speaker rms 100 watts I'm giving them 70, I know I'm not maxing the speakers out but 70 clean watts have them sounding good. If I ever burn the JL amp out will probably go with the DD audio amp.
Last edited by arlington; 05-19-2018 at 12:55 AM.
Thread
Thread Starter
Forum
Replies
Last Post