Pioneer TS 6900 vs Vo M 6x9
#11
Mike I would enjoy what you have for now and plan and budget a full overhaul over the winter. The vo are a definite value and performer. There is also a place that makes a horn bridge for 13 down factory lids and may fit some aftermarket. Ideally you can run your fairing and tourpack off the 4180 front channels in parallel and just run Mmats top and bottom, get something else decent for rear pods, a second 4 channel for the vo and run some horns front and rear off the other 2 channels. Lots of ways to skin the cat so take your time.
The following users liked this post:
Moto Mike (07-04-2017)
#12
Originally Posted by Moto Mike
Did not realize bro...Kenwood 998, HAT Legatia's w/ Clarus tweets in the fairing, Titan II's in lowers, run by 4180, pods BT 7.1's, BT 6x9's in lids run by Tn.4 900...Clients bike BT 7.1's in fairing, Vo's in lids heard that set up with fairngs on... then faded to rear... Vo's were shaking my pant legs!! MM
If I was a betting man, I would bet a 12 pack that the VOs will possibly work pretty good on your sled due to the other presence of highs and full range sound on your sled.
On the other hand, Im betting the customers sled is leaving a shix ton of sound off the table as he will not retain much of that hit/thump above 30 mph.
I would roll VOs on yours and Pioneers on the customers.
Just my 1.5 cents!!!!
T.
The following users liked this post:
Moto Mike (07-04-2017)
#13
#14
#16
Thanks for the reply's one and all...just got the itch ya know! I'm gonna try em both...got some Pioneers on the way, had some bonus points on a CC I was gonna lose, turned em in for a Amazon gift card...got a deal from Amazon warehouse $75!! Now the question..I got HD CVO pre 13 lids will these bolt right up, do I need to use the BT adapters..anybody go from HAT's to these! Heard the horn was hard to get clearance on some lids!
#17
Thanks for the reply's one and all...just got the itch ya know! I'm gonna try em both...got some Pioneers on the way, had some bonus points on a CC I was gonna lose, turned em in for a Amazon gift card...got a deal from Amazon warehouse $75!! Now the question..I got HD CVO pre 13 lids will these bolt right up, do I need to use the BT adapters..anybody go from HAT's to these! Heard the horn was hard to get clearance on some lids!
The following users liked this post:
Moto Mike (07-04-2017)
#20
I hope they are not too much bigger than the HAT's, I have to pull up and tilt the lid at just the right angle, and squeeze the edge of the lid past the 7.1 pod's and the magnet scrapes the top lip of the bottom bag...as it is with the HAT's!! I'm gonna try both the Pioneers and the VO's which do ya think I'll keep!