Kw miswiring message
#1
Kw miswiring message
Rode to a friend's house yesterday and everything was fine, 10 hour later I get a miswiring, check wiring and turn off message ok the head unit. This morning I ran new wires for the speakers which is what I've read is most likely to cause that message.. That didn't help any, I reset the HU, tried moving around wires to see if I had another short and still nothing. Then I noticed the amp isn't powering on, maybe because the remote from the HU is powering it on.. Any ideas guys.. B2 amp, Kenwood 562 hu
#2
Join Date: Aug 2014
Location: Lockport Illinois
Posts: 2,640
Likes: 0
Received 469 Likes
on
394 Posts
Kw miswiring message
Rode to a friend's house yesterday and everything was fine, 10 hour later I get a miswiring, check wiring and turn off message ok the head unit. This morning I ran new wires for the speakers which is what I've read is most likely to cause that message.. That didn't help any, I reset the HU, tried moving around wires to see if I had another short and still nothing. Then I noticed the amp isn't powering on, maybe because the remote from the HU is powering it on.. Any ideas guys.. B2 amp, Kenwood 562 hu
If all is good the amp should have an internal fuse that may have popped
#5
#6
Try doing a factory reset on the hu.
Make sure none of your speaker outputs on the hu are grounding out, skinned, or pinched.
You could try putting a ground wire from the chassis of the hu to a grounded location on the bike. Some hus I had back in the car audio days were picky about having a chassis ground.
Make sure it has the latest firmware update.
Good luck. I know you need your Pantera when you're riding.
Make sure none of your speaker outputs on the hu are grounding out, skinned, or pinched.
You could try putting a ground wire from the chassis of the hu to a grounded location on the bike. Some hus I had back in the car audio days were picky about having a chassis ground.
Make sure it has the latest firmware update.
Good luck. I know you need your Pantera when you're riding.
#7
I didn't have any speaker wires hooked to the HU at all just the ones thay were connected to the axxis and it still says the same thing. I tried wiring the speakers directly to the HU and the way it was which is thru the amp and nothing.. However 2 times throughout the day it would work and as soon as I'd turn it off it would work again
Trending Topics
#10
Not sure what I did but it's workin fine now.. I had everything disconnected for 2 days and went out this morning to re do everything, every u used wire is capped off and stuffed inside some loom.. Now I get to go back and redo all of the damn settings again which is my least favorite part lol