2014 FLHTK Bike Tronics install for a newbie.
#54
from BT (Remove speaker harness from plastic speaker pods)
I understand you need to remove the positive and negative from speaker, but was not sure if you are referencing the removing of the harness from the pod.
#55
Yes as Paul pointed out the black bracket is for the CB and bolts to the BT bracket. Now that I think of it I drill another hole in the CB bracket to move it back further to allow more room for wiring. Every little bit counts when you have to put the fairing back on.
#57
The plug on the line leveler will connect directly to the plugs that you disconnected when the pods were removed. See pic below.
Then the RCA cables will connect from the LL's to the RCA speaker Inputs on the AMP.
Next the speaker wires coming from the AMP outputs will connect directly to the speakers.
#58
With the BT Speaker and Bracket kit you can leave the speakers in the pods along with the wires . You won't be using them.
The plug on the line leveler will connect directly to the plugs that you disconnected when the pods were removed. See pic below.
Then the RCA cables will connect from the LL's to the RCA speaker Inputs on the AMP.
Next the speaker wires coming from the AMP outputs will connect directly to the speakers.
The plug on the line leveler will connect directly to the plugs that you disconnected when the pods were removed. See pic below.
Then the RCA cables will connect from the LL's to the RCA speaker Inputs on the AMP.
Next the speaker wires coming from the AMP outputs will connect directly to the speakers.
Stock speaker harness from out of the pod's
Last edited by hbsoldier3; 12-27-2015 at 09:09 PM.
#59
Those instructions are for installing the speakers and brackets only.
These are the instructions Dave needs to install the speaker and amp kit with the LL's. They do show a transformer rather than the LL's. The pic I posted of the LL and wiring instructions should make it clear.