2014 FLHTK Bike Tronics install for a newbie.
#141
#142
I start by getting the bottom of the fairing tabs inside the skirt, then move to the right upper I have to lower the fairing to get the bolt to line up, which in turn pops the bottom out of the skirt; no big deal. Then I go and out the left upper in a few turns, and pop the lower part back into the skirt. From there I just tighten up the top bolts a little more start the bottom screws then make sure the bottom tabs are inside the skirt, then tighten all the bolts. Everybody is different, but this works for me.
The following users liked this post:
indiggio (05-09-2016)
#143
#144
Originally Posted by Warchild1$
Thanks that was kinda the approach I was taking, finally got it on but noticed about 1/8 gap around the vent. Snug and tight everywhere else. Patience was used up Might try again tomorrow. Gonna take a ride but the BT systems rocks in the garage
U don't want to jam that fairing on, pinching RCAs, harnesses, wire bundles, etc.... It's popping out of the bottom clips cause it's high-centering on your recent additions.
Been there done that Brotha. Take the time to get a lay of the new land under there.
T.
The following 2 users liked this post by Tailwind:
indiggio (05-09-2016),
Warchild1$ (05-09-2016)
#145
Thread
Thread Starter
Forum
Replies
Last Post