Fader control was designed to work with boom amps... aftermarket amps get the shaft at the moment thats all. Software may change this but as it currently stands ALL aftermarket setups should have NO fader

 

I have a question. Does the 135_off.bin display the same if the bike is running? Because mine display a bin.on when running and a bin.off while off.

 

Good question... never tried reading it if started AFTER entering diagnostic mode..... hmmm

 

How do you entering diagnostic mode when the bike is running?

 

You say the EQ is really flat now. Can the Bass and treble control along with the amp settings overcome that once I readjust the amp for the flash?

 

Hold down the same button as before while you start the engine and wait for the accept button before letting go.

I decided to try because people complained that their bikes sounded different when running and I think this could be the reason.

 

I suppose it depends on your amp? Mine isn't adjustable so Im pretty much stuck with what it is. The HD radio settings honestly make only the smallest most minute difference

 

Thanks I'll give it a try.

 

Do you have 135_off.bin

 

No I have the stock 00.Off.bin.

I did try restarting the bike the other day when it was hot and held the mute button in but the radio just came back on. It would not enter diagnostic mode.