Wow PhantomMaxx, looks good.. How long did the whole install take you? Is it like changing the stock shocks? Can't wait to get my SAS installed. Is the compressor loud? and did it take long to raise and lower the bike? Thanks let me know after you get a chance to test ride your bike. By the way what seat is that your using?.

 

OK, I did the install of the temporary switch. I found a momentary (on)-off-(on) toggle switch and a 15 amp push-button circuit breaker at a local electronics store. Here is my wiring set-up:


Here the switch under the front of the seat:


Here is me reaching for the switch. In the pic my legs are down, but it's just as easy with my feet on my floorboards.

 

It's about as easy as changing the stock shocks and then routing a cable and a hose. The electronics was easy too, only 4 small wires in one cable. The compressor is about as loud as an electric back massager. As far as raising and lowering check out the link below.

CLICK HERE to see the SAS in action

 

I want this on my bike so friggin bad . Looks like my Commander in Chief is going to pay for some of it ! With the SAS can you adjust it as you ride ?

 

Can you ride it slammed all the way without any tire rubbing? Looks great.

 

Damn.. now I'm thinking...

Thanks for the Post !!!!


Mike
NY

 

How do you change the oil in the tranny after this is installed? Looks cool! How much do these units cost?

 

Yes.

 

I do.

 

Look at his install pics....the pic with the unit hanging by one end...that should answer your question. CCCS is working on a solution so that this doesn't have to be done.

The units retail for about $1650.