Originally Posted by jeffusvon

thanks for posting this. I went with the same set up and all worked well.. Just wanted to thank you for posting since i never believe the sales websites. Hearing from fellow rider and wrench turner is worth its weight in gold. Thanks again for making my life easier and a little less stressful

Originally Posted by Klock20

Looking good! Did you notice a increase in handlebar vibration?

Originally Posted by Klock20

I did the LA choppers Billet 6" pullbacks with Guage mount and they vibrate bad between 2600 and 3000 so basically cruising speed I had drag specialties 5.5" pullbacks on before and they didn't at all I do have sock bushings though.

Originally Posted by shiftace

What is that cover under the speedo housing over the warning light holes? Those holes are the reason I don't want to use single gauge cups that I've found online.

Originally Posted by Hellgoblin

my Arlen ness poly urethane bushings are fine i have a little slight vibration over stock but it’s barely more noticeable and very manageable.

Originally Posted by Hellgoblin

big Al’s gauge bracket comes with cover

Originally Posted by shiftace

Thanks. They're on eternal backorder for wrinkle black setups so I'll keep searching.

Originally Posted by Hellgoblin

Just installed my thrashin 6.5 risers with 1.5inch pull back used stock cables and wires had to adjust brake line to make work but works with stock front brake line and stock clutch cable just have to route the clutch cable out of triple tree…. Used a big Al’s mount relocation gauge bracket.

Originally Posted by Mopar5599

Did you reuse your stock bars or used different brand. Do you know the part number for the gauge kit from Big Al?