With my 2018 Fat Bob being delivered soon, I'm trying to sort a few "maintenance" things out. While I have a wealth of standard and metric tools I have little to no Torx bits, which I believe are pretty common on most of the allen head fasteners.
Can anyone chime in with the common sizes required. I figure I best buy a few good one over a cheap set where 80% don't get used. If there are any other "special" tools that are useful for general maintenance, repair and upgrading, feel free to let me know.

Thanks!

 

The derby cover screws are T-27. A lot of folks mistakenly use a T-25, then they post here asking how to get a stripped Torx screw out...

 

yes. And the 27 typically does not come in a set. I have two five piece sets one metric and one standard. Had to buy the 27 separate

 

Thanks Gents!

I think I'll find a service manual as well to ensure I have the right torx and torque!

 

I have this. It includes all I need.

 

I have this one as well, worked great so far.

 

Thanks for the info and the link.
I'll see if amazon.ca offer the same thing and get it ordered. will be the cheapest thing I buy for this HD I think..

 

The service manual will be the best tool you ever buy after T27 bits and drivers.

 

You may consider getting a small set of the ones with the security hole. You will at times come across a Torx with a nipple in the bolt head. There is a Torx bit that has a hole in the center to allow you to remove them. They also work on normal Torx bolts

 

I 100% agree, dealer wants close to $200 Canadian for one, so I'll be looking online. Is there one for the Fat Bob or just the 2018+ Soft Tail line up?