2020 Low Rider S owners
#181
#182
Thanks. I like the way they look a lot more than I thought I would. The wrinkle finish matches the factory finish pretty darn well. No tune. Left the baffles in and sent it. Oklahoma makes you pay sales tax after the fact when you get the title and go to register and it always hurts, so all big ticket modding is on the back burner till a later date.
#183
No big deal, I'm not afraid of my grinder, or cutting/welding if necessary. I'm going to have to cut and weld on some bracketry to get my headlight to fit anyways, and am pretty sure I will be opening up the headlight hole in the fairing a little.
#184
I’ll order one to prototype, but it looks like all it’ll need is to have the two ears cut down to narrow it to the old style headlight block width.
Last edited by Mchad; 09-20-2019 at 06:50 AM.
#185
Yeah, I’m going to have to figure something out for my headlight as well. I have a JW Speaker adaptive 2 head kit in a standard black bucket, that I want to use instead of the standard issue LED, but the new mounting block is too wide. I will have to grind/cut it down a bit.
I’ll order one to prototype, but it looks like all it’ll need is to have the two ears cut down to narrow it to the old style headlight block width.
I’ll order one to prototype, but it looks like all it’ll need is to have the two ears cut down to narrow it to the old style headlight block width.
#186
#187
CAN’T WAIT!! I’d like to see both gauges up there or at least the tach. The speedo in the stock spot isn’t horrible but the tach is just short of useless where it sits. And there’s a “roughly” h shaped bracket that picks up the 4 screws. Hardest part would really just be the wire extensions. A flat piece of .060 7075 cut to shape and size and you got the dash. Didn’t want to mess with it yet as there’s two big rally’s in the next 30 days but if it rains the next week like they’re predicting I may have found something to occupy my hands.
Last edited by big ron; 09-20-2019 at 05:21 PM.
#188
Speaking of moving/changing gauges, would it be possible to remove the dual gauges and textured harness from the fuel tank, and install a single gauge mounting to the center of the bars? Is the fuel tank painted underneath that harness?
I'd really like to install a '18+ Fat Bob gauge on or above the riser. Does anyone know if I could use the '18+ Fat Bob gauge on the Low Rider S? Ideally something like this:
I'd really like to install a '18+ Fat Bob gauge on or above the riser. Does anyone know if I could use the '18+ Fat Bob gauge on the Low Rider S? Ideally something like this:
#189
The following 5 users liked this post by emdx3:
24v (09-21-2019),
rauchman (01-30-2022),
sbrooks64 (09-21-2019),
Sideburn (09-21-2019),
Windycityblues (09-21-2019)
#190
I'm going in to my dealer next week to hopefully get a deal done and was wondering what exhaust I should add to the package.
V&H Slash Cuts were on my list and I reckon I'm going to go with them after seeing you bike...so, thanks for posting! Hope you're enjoying it.
The following users liked this post:
Windycityblues (09-21-2019)