Yes, that is easy, it's printed on the cable. The big question was the sizing, since hd seems to have their own formula to measure cable length. Going with @OldMike suggested, the stock length being 31", I ordered: 37200329 - 34", but that turned out to be exactly the same size as the stock cable! Hoping for 3" longer I ordered the 37" (37200326) and it was.

So I can say for-sure, that the stock 2020 fxlrs upper clutch cable is 34"

 

Yes. this was always a problem since at the time we never had a published part number and length for the stock cable to compare to.
I took a chance and bought a stock FXLR (not S) cable and it worked for a 5-1/2" pull back riser (miss wrote 4-1/2 in another post), but again could not give you an exact useful measured length.

 

I appreciate you getting me close!!! And now we know! I went with the bungking 6" riser with 2" pull back and the 37" was perfect.

 

And that makes sense based on a 34" measurement for the stock FXLRS cable, now to remember all this.

 

1500 miles in and added a couple
more things. Moons taillight and Thrashin’ Escape bags. I have a rack for the sissy bar and a huge bag if I need touring capacity but these saddlebags are perfect for everyday use.

Also not allowed to run the Moons turn signals in the UK unfortunately due to spacing laws.

Road Warrior will be on soon to help with the lines a little, add a bit of height to the front.

 

whats up guys new to the forum just got my 2020 low rider s and I love it already!! so far I've done vance and hines 2in2 big radius exhaust and screaming eagle tuner and just recently installed my cruise control I uploaded the installation video on my youtube chanel (Affy entertainment).
the link is below. Next ill be installing the 6.5 inch drag specialize raisers ill have that video up soon as i get the parts.


new cruise control from HD.

 

Nice video, hope to see more.

 

OK guys in this one i installed the drag specialties 6.5 inch raisers hope it helps out someone

 

Nice video (what camera do you use?) you found out it's not easy to install 6.5" pullback risers. 5.5" is easier, cables and wires don't get as tight, I'm more comfortable with a bit more slack.
Tip: Extra slack is available for the turn signal wires at the signals, loosen up the hand control mountings and pulling slack through the bars.
Tip: I used a longer top clutch cable to follow stock routing on all cables and wires, I think it looks cleaner.

Thanks,
Mike

 

Thanks perfect timing just about to do my 5.5's as its wet playtime here in GA