Nice. Looking into one for my sportster.

 

I installed this little medallion on my fender to cover the seat hold-down hole. Part number 67668-05, used for years on the headlight of many models.

 

I can't see the picture.

 

adm,

i have never looked that close at an ST, does your struts have a block off plate for the side mount turn signals ? or are the struts different than a FXLRS

i like the signal mount from the ST, have thought about ordering one, just havent looked in to the removal of the S signals yet.

 

Tracker Die has some clean little turn signal block off plates for our bikes. Using em on mine since going to an integrated taillight. I'll eventually powder em texture black but honestly I kinda never even look at em lol

 

I have a set of those from Cycle Visions sitting on my shelf. Never used them. If someone needs them I will let them go cheap.

Zach

 

The turn signals aren't mounted on the struts on the ST, because the bags would be in the way. They are mounted as part of the baseplate for the brake/run light on the rear fender. The fender struts are solid at the rear end, so need for any kind of blanking plate - they are different struts.

 

Here you go:

 

I also did the moons tail light relocation. I found it easier to remove the rear fender then the sort cut utube install. Keep forgetting to order the hair custom block of plates because you can’t really see the hole with the bags.

 

this is what i was curious to...i knew they didnt mount on the strut.

i like the ST mounting, and was curious as to swapping that onto an S...i just hate plugs and fillers. i cannot stand my primary since i run forward controls.