What did you do to your 18+ softail today?
#4131
They lower the noise output and give the exhaust note a much more aggressive sound.
It lower's the exhaust note as well, deeper sound.
#4133
did you have to cut the threaded rod to install that coupler? I wonder if the smallest ones would work in a set of Rinehart 2-into-2's using existing holes.
#4134
I wanna say I did trim the threaded rod on the torque insert to center it. I put it on a while ago. It was a very easy install.
The following users liked this post:
Doublefelix (08-28-2022)
#4135
Test fit new fender
New project. Test fitting the Kodlin shorty rear steel fender. Fit and finish of this product is top notch. 260 tire tucks nicely right under the fender. Obviously if I had a total loss of air pressure the tire would hit. No rubbing when suspension is aired up. Here are pictures aired up and slammed.
#4136
Little heat paint and good to go!
The following users liked this post:
OzzyMozzy (08-29-2022)
#4137
Little heat paint and good to go!
update, I have been running the torque insert in the end cap bolt. I always figured it would do more running it in the actual baffle hole but the baffle blocks access. I pulled the baffle, did some grinding. Now I can run it in the baffle bolt hole.it is now tight to the baffle. I also pulled the packing of the baffle. I gained low end and it sounds amazing!
#4138
#4139
#4140
Great work going on here. Can't wait to see the finished product.
Zach
Zach
New project. Test fitting the Kodlin shorty rear steel fender. Fit and finish of this product is top notch. 260 tire tucks nicely right under the fender. Obviously if I had a total loss of air pressure the tire would hit. No rubbing when suspension is aired up. Here are pictures aired up and slammed.