How did you mount the plate vertically? Thanks.

 

There is a screw that you take off in the middle then you twist the section until its vertical. Literally takes a second, once you look at the holder you will see what i mean.

 

Damn, those are too cool. You just cost me another 105$ haha.
I'm still trying to decide on what I want for the rear. Killer Custom makes a cover for the swing arm pivot, and I'm thinking about grabbing that as well.

I want a different sissybar too, the short stubby one is not really fitting of that bike's style, and it's rather annoying to get a backpack attached to it since it's so short.

 

They are of good quality Fran. I haven't had to retighten mine at all since I put them on there. And they look the same as they did back then, though I don't ride in the rain so there's that. I don't think you'll be disappointed though

 

Yes, I have the one from Custom Dynamics... it was an easy install and no cutting of wires. And it was inexpensive... I think it was $40.
https://www.customdynamics.com/led-l...breakout?cat=2

Steve

 

You have 2 Fat Boys in that garage? Damn. Are they both yours or one your wifes or friends?

 

My brother has one too.. his is black, mines two tone.
Steve

 

Original Owner replaced the rear lights and the rear reflector with stealth tail lights that flank the license plate holder mounted on the rear fender.
https://www.bikecraft.net.au/-bikecr...on-fatboy-2018

I added the Custom Dynamics Tri-Radius Frame with LED Lights for Run/Brake/Turn and To light up the plate.
https://www.customdynamics.com/tri-h...e-illumination

A different setup from what Monteman1971 has.

Though the cost of his is much more reasonable. I'm not sure I would have put down the money that the other owner did for the upgrade if it wasn't already on the bike. lol.

I will say Custom Dynamics as a company and manufacturer are great to deal with.
As I have custom plug and play wiring that came with the stealth lights on that tail tidy setup, I needed some help to make sure I wired it right, and they were super patient with me, and helped me through the process so that I got it right the first time round when installing it.
No cutting of wires either.
I would easily buy from them again.


Rear Tidy Tail Lights and Plate Relocated to back of Fender and Tri-Radius Frame

 

Wow that looks great. Much better than stock IMHO.

 

I was looking at this: https://chromeglow.com/products/fat-...vidson?id=2466
The doublerow in smoke lense would look great.
I'd like to run this along with my turn LED bullet signals.