Everything 2018 FatBoy thread
#1061
#1062
I have the Kodlin Elypse ordered as part of my ape swap, but my cruise control is still 18 weeks on backorder. So, I'm looking at the rear. I want to get the plate off the signal stem. Was looking at the Cycle Vistions under fender plate mount, but they are sold out right now. Those Neowise would fill the stem hole perfectly. I may get the "Slick Signal" and piggyback the Kodlin's. It would make for a clean look but still be bright as hell when riding.
#1063
#1064
#1065
I thought about doing a swingarm plate then putting HD's short stems along with the CD ProBeam setup. I'm probably going with the under fender because of water spray in the rain, so going Kodlin will match my front signals, stay sleek and would allow detatchable bags for trips.
#1066
The following users liked this post:
Monteman1971 (08-11-2022)
#1067
The following users liked this post:
Doublefelix (08-11-2022)
#1069
#1070
I used the 118W and the 2 nuts and I think... one of them has a washer or lockring.
I can check my footage and see what I did, you'll have to give me a little bit.
I drilled on the nearest line of the baffle itself to the end of the baffle, and installed them in. Made it easy to drill a hole for the stud.
The 158W will not fit, so dont get them.
EDIT:
So it's
Bottom Knut, Bafflewall, Lockwasher, Top Knut.
I used blue Loctite, which I realize is completely pointless, lol.
Use Red Loctite... But I'm not sure you actually need loctite for these.
They haven't moved at all since I installed them.
Last edited by FranBunnyFFXII; 08-11-2022 at 11:51 AM.
The following users liked this post:
HarleyDEU (08-11-2022)