lets see the Apes!
#401
Who's replaced their stock 1 piece top handlebar clamp setup for a better holding clamp and who'd you use? Over the last two years, I've had my bars slip twice and it's a pain in the *** taking it apart, reset, and put 1/2 a turn on the bolts. I've had issues in the past with bushing changes causing my inner fairing to not fit down properly, so figured I'd ask around to see what you guys who've changed the bushing and entire clamp on your rushmores went with. Thanks.
#402
12" LA Choppers. Here is a good before and after if anyone wants to see a height comparison to the stock bars. I am 6' tall and the bars are just below shoulder height. Very comfortable. When this 10 inches of snow melts, I will be able to give it a longer ride. I also changed out the brake and clutch lines because I did not want the black lines.
#404
Not sure if it's been discussed and I missed it, but found out today that Namz now makes complete 48" long hand control wiring harnesses, $60. So instead of having an extension plug into the factory wiring and having plugs buried in your bars, you just run the Namz harness from switches to under the fairing. I ordered a set today.
#405
#406
Got a link on this,
Sounds like a smart way to go, don't know the part # do you, trying to find on the NAMZ site.
Thanks!
Thanks!
Not sure if it's been discussed and I missed it, but found out today that Namz now makes complete 48" long hand control wiring harnesses, $60. So instead of having an extension plug into the factory wiring and having plugs buried in your bars, you just run the Namz harness from switches to under the fairing. I ordered a set today.
#407
#408