lets see the Apes!
#355
11-01-2015 | 03:41 AM
Cruiser
Joined: Apr 2012
Posts: 116
Likes: 2
From: Lebanon, OR
#356
11-09-2015 | 08:47 AM
Road Master
Joined: Jul 2009
Posts: 830
Likes: 44
From: Illinois
Got my 10 Inch Wild One Reapers
Hope to have them installed this weekend
Will post completed pics
Nice build quality. Large opening for wires, Smooth cut out.
Nice weld at the control end
Here is a taste
The corners are supposed to be smoothed and rounded
We will see how the wires pull
[/URL]
#357
12-18-2015 | 05:43 AM
Road Warrior
Joined: Aug 2013
Posts: 1,619
Likes: 57
From: New York
The CVO TBW eliminates the green connector altogether. You just have to run the wires and insert the pins into the housing when they're through. Unless youre doing it on a 14-up, then you have to repin it with sockets and swap the male connector out to female (or visa versa)
I don't have the heated grips, but sometimes I wish I did!
I don't have the heated grips, but sometimes I wish I did!
#358
12-18-2015 | 06:11 AM
Thread Starter
|
Road Master
Joined: Jun 2012
Posts: 1,088
Likes: 2
From: Mo
Here is what I used...
NHCX-J088" Extension w/Matching Wires, 2011-Up Softails, 2012-Up Dyna & ALL 2014-Up Models except V-Rod.$34.32
http://www.namzcustomcycleproducts.c...XTENSIONS.html
NHCX-J088" Extension w/Matching Wires, 2011-Up Softails, 2012-Up Dyna & ALL 2014-Up Models except V-Rod.$34.32
http://www.namzcustomcycleproducts.c...XTENSIONS.html
#359
12-20-2015 | 07:47 PM
Cruiser
Joined: Nov 2011
Posts: 132
Likes: 0
From: Hixson, tn
Got my 10 Inch Wild One Reapers
Hope to have them installed this weekend
Will post completed pics
Nice build quality. Large opening for wires, Smooth cut out.
Nice weld at the control end
Here is a taste
The corners are supposed to be smoothed and rounded
We will see how the wires pull
[/URL]
Hope to have them installed this weekend
Will post completed pics
Nice build quality. Large opening for wires, Smooth cut out.
Nice weld at the control end
Here is a taste
The corners are supposed to be smoothed and rounded
We will see how the wires pull
[/URL]
#360
12-23-2015 | 09:07 AM
Road Master
Joined: Jul 2009
Posts: 830
Likes: 44
From: Illinois
Slow
Bars are off and being torn down on my Bench (Kitchen Table)
Have Holiday stuff and other projects. So this is getting done real slow
But Its gonna rain all weekend here after X mas
I should have them done by then
Ill post up when Im finished
Ill leave one tip for depinning the controls
You need to pull the release for the pin lock with needle nose pliers
This makes removing the pins much easier
Insert either Needle nose or forceps in the two slots pointed out by the yellow arrows pull up to release lock