Missing the waypoint
#11
#12
This was posted by me on another Harley Forum website a few weeks ago.
I bought a 2014 Ultra Mar. 1. I didn't find out about the insane 9 wave point limitation until after the fact. After calling Harley customer service they informed me they had several complaints about the GPS wave points and the maps data base being 2 years out of date. They said they are working to increase the wave point numbers. I suggested they remove the limitation completely. In our discussion I informed them I had rides with up to 138 wave points to keep the GSP on the planned route.
I told them I was very disappointed with the GPS. (it was a pile of junk until they remove the limitation and update the GPS date base). BTW the cost for a one time update is $149.00 per the website. The revision date is 12 2012. (unacceptable) I informed them I was going to mount my old Zumo 665 on my new bike (Which has free life time map upgrade).
Theirs way around the limitations. Create several routes with only 9 points including start and finish. You can use Base camp or Ride planner, save the route as hdroute.gpx file. Rename the file and copy it onto a USB flash drive and load it into the bike GPS via the USB port. I number them 1,2,3,4,5 etc.
As the first route is completed start the next route. I position the finish point and the start of the next route a couple of miles apart to give me time to select the next route.
I hope this helps
I bought a 2014 Ultra Mar. 1. I didn't find out about the insane 9 wave point limitation until after the fact. After calling Harley customer service they informed me they had several complaints about the GPS wave points and the maps data base being 2 years out of date. They said they are working to increase the wave point numbers. I suggested they remove the limitation completely. In our discussion I informed them I had rides with up to 138 wave points to keep the GSP on the planned route.
I told them I was very disappointed with the GPS. (it was a pile of junk until they remove the limitation and update the GPS date base). BTW the cost for a one time update is $149.00 per the website. The revision date is 12 2012. (unacceptable) I informed them I was going to mount my old Zumo 665 on my new bike (Which has free life time map upgrade).
Theirs way around the limitations. Create several routes with only 9 points including start and finish. You can use Base camp or Ride planner, save the route as hdroute.gpx file. Rename the file and copy it onto a USB flash drive and load it into the bike GPS via the USB port. I number them 1,2,3,4,5 etc.
As the first route is completed start the next route. I position the finish point and the start of the next route a couple of miles apart to give me time to select the next route.
I hope this helps
#13
Another thought on the OP original question is not to use city as waypoint but a spot on the highway leading away from city. Most riders intent is not to go to the center of every small town but to find best route thru or around town. By making the waypoint just outside of town the GPS will calculate shortest route to that waypoint.
#14
Another thought on the OP original question is not to use city as waypoint but a spot on the highway leading away from city. Most riders intent is not to go to the center of every small town but to find best route thru or around town. By making the waypoint just outside of town the GPS will calculate shortest route to that waypoint.
Is the GPS recognizing the waypoint dot as a destination?
#15
When you add waypoints via HOG ride planner make sure you zoom in pretty far too take a good look at the waypoint making sure it is properly placed on the road. If not careful placing waypoints, they can actually be off the road or on a side road or the wrong side of an intersection. The results of poorly placed waypoints is you might not ride close enough to them to trigger arriving at the waypoint. Then the GPS want to reroute you back to it.
Tips I have come to used for waypoints:
1. Always zoom in REALLY close on ALL waypoints to ensure it is on the road I intended, the correct direction of the road (the right side of the road not the left side), etc...
2. Do NOT place a waypoint in an intersection. This has bitten me several times. Either the waypoint was at the wrong side of the intersection and did not get triggered or the waypoint was triggered and the GPS has to figure out the next directs while the light is green. In other words traffic is flowing and I do not know which way to go because the GPS is thinking. I always place a waypoint a 1/4 mile before or after an intersection.
I have over 12,000 miles on my 2014 Limited. I use the GPS a lot and I think its the best GPS I have ever used once I figured out some of its squirts. The above waypoint issues I mentioned are a limitation of Ride Planner and human error, not the HD GPS.
Tips I have come to used for waypoints:
1. Always zoom in REALLY close on ALL waypoints to ensure it is on the road I intended, the correct direction of the road (the right side of the road not the left side), etc...
2. Do NOT place a waypoint in an intersection. This has bitten me several times. Either the waypoint was at the wrong side of the intersection and did not get triggered or the waypoint was triggered and the GPS has to figure out the next directs while the light is green. In other words traffic is flowing and I do not know which way to go because the GPS is thinking. I always place a waypoint a 1/4 mile before or after an intersection.
I have over 12,000 miles on my 2014 Limited. I use the GPS a lot and I think its the best GPS I have ever used once I figured out some of its squirts. The above waypoint issues I mentioned are a limitation of Ride Planner and human error, not the HD GPS.
#16
I think this is like anything else. It will take a little time to come to learn the GPS system and HOG ride planner. Once you know it well you might come to enjoy it.
I have been using it since August and think its the best GPS I have ever used. Their are some bugs that still need to be work out.
#17
When you add waypoints via HOG ride planner make sure you zoom in pretty far too take a good look at the waypoint making sure it is properly placed on the road. If not careful placing waypoints, they can actually be off the road or on a side road or the wrong side of an intersection. The results of poorly placed waypoints is you might not ride close enough to them to trigger arriving at the waypoint. Then the GPS want to reroute you back to it.
Tips I have come to used for waypoints:
1. Always zoom in REALLY close on ALL waypoints to ensure it is on the road I intended, the correct direction of the road (the right side of the road not the left side), etc...
2. Do NOT place a waypoint in an intersection. This has bitten me several times. Either the waypoint was at the wrong side of the intersection and did not get triggered or the waypoint was triggered and the GPS has to figure out the next directs while the light is green. In other words traffic is flowing and I do not know which way to go because the GPS is thinking. I always place a waypoint a 1/4 mile before or after an intersection.
I have over 12,000 miles on my 2014 Limited. I use the GPS a lot and I think its the best GPS I have ever used once I figured out some of its squirts. The above waypoint issues I mentioned are a limitation of Ride Planner and human error, not the HD GPS.
Tips I have come to used for waypoints:
1. Always zoom in REALLY close on ALL waypoints to ensure it is on the road I intended, the correct direction of the road (the right side of the road not the left side), etc...
2. Do NOT place a waypoint in an intersection. This has bitten me several times. Either the waypoint was at the wrong side of the intersection and did not get triggered or the waypoint was triggered and the GPS has to figure out the next directs while the light is green. In other words traffic is flowing and I do not know which way to go because the GPS is thinking. I always place a waypoint a 1/4 mile before or after an intersection.
I have over 12,000 miles on my 2014 Limited. I use the GPS a lot and I think its the best GPS I have ever used once I figured out some of its squirts. The above waypoint issues I mentioned are a limitation of Ride Planner and human error, not the HD GPS.
#18
I had this same experience last week and was getting frustrated. I was able to figure out how to stop navigation to a specific waypoint but I don't remember the exact steps. I will have to step through it on my tri-glide when I get home tonight.
It had something to do with getting to the list of destinations on the trip, selecting the waypoint "destination" in the list and selecting "Stop". Once I selected Stop, it recalculated the rest of the trip from wherever I was currently at the time.
It had something to do with getting to the list of destinations on the trip, selecting the waypoint "destination" in the list and selecting "Stop". Once I selected Stop, it recalculated the rest of the trip from wherever I was currently at the time.
When a route is started and a waypoint is missed along that route, the GPS will continue to try and route you back to that waypoint no matter how far you travel. Does anyone know if the missed waypoint can be canceled some way so you can continue on the planned route? thanks.
#19
When you add waypoints via HOG ride planner make sure you zoom in pretty far too take a good look at the waypoint making sure it is properly placed on the road. If not careful placing waypoints, they can actually be off the road or on a side road or the wrong side of an intersection. The results of poorly placed waypoints is you might not ride close enough to them to trigger arriving at the waypoint. Then the GPS want to reroute you back to it.
Tips I have come to used for waypoints:
1. Always zoom in REALLY close on ALL waypoints to ensure it is on the road I intended, the correct direction of the road (the right side of the road not the left side), etc...
2. Do NOT place a waypoint in an intersection. This has bitten me several times. Either the waypoint was at the wrong side of the intersection and did not get triggered or the waypoint was triggered and the GPS has to figure out the next directs while the light is green. In other words traffic is flowing and I do not know which way to go because the GPS is thinking. I always place a waypoint a 1/4 mile before or after an intersection.
I have over 12,000 miles on my 2014 Limited. I use the GPS a lot and I think its the best GPS I have ever used once I figured out some of its squirts. The above waypoint issues I mentioned are a limitation of Ride Planner and human error, not the HD GPS.
Tips I have come to used for waypoints:
1. Always zoom in REALLY close on ALL waypoints to ensure it is on the road I intended, the correct direction of the road (the right side of the road not the left side), etc...
2. Do NOT place a waypoint in an intersection. This has bitten me several times. Either the waypoint was at the wrong side of the intersection and did not get triggered or the waypoint was triggered and the GPS has to figure out the next directs while the light is green. In other words traffic is flowing and I do not know which way to go because the GPS is thinking. I always place a waypoint a 1/4 mile before or after an intersection.
I have over 12,000 miles on my 2014 Limited. I use the GPS a lot and I think its the best GPS I have ever used once I figured out some of its squirts. The above waypoint issues I mentioned are a limitation of Ride Planner and human error, not the HD GPS.
#20
I had this same experience last week and was getting frustrated. I was able to figure out how to stop navigation to a specific waypoint but I don't remember the exact steps. I will have to step through it on my tri-glide when I get home tonight.
It had something to do with getting to the list of destinations on the trip, selecting the waypoint "destination" in the list and selecting "Stop". Once I selected Stop, it recalculated the rest of the trip from wherever I was currently at the time.
It had something to do with getting to the list of destinations on the trip, selecting the waypoint "destination" in the list and selecting "Stop". Once I selected Stop, it recalculated the rest of the trip from wherever I was currently at the time.
Thanks.