Installing 2" Pullback Bars FLHTK (Pics included)
#211
#213
#214
Today I'm installing the reduced reach bars 56176-08 on my 14 SG..I've ran into an issue.I ran the left and right switch pak wiring inside the bars.They are a few inches short now,they won't reach the connectors they gotta plug into under the audio sys.I'm wondering if anyone else has tried this and found a solution?The bars look so clean without the wiring ty-wrapped to the outside.TIA
Dan
Dan
#216
#218
I liked them but for a bit more pull back I just installed 2+2 narrow sweepers, have not been on the road yet. I have them pulled back, I can see my hands in the bottom of the mirror but I'd say they will work with stock mirrors too. I usually have to get a new left grip with new bars.
There is a thread about these bars around here somewhere.
http://www.khromewerks.com/SWEEPER-B...1029-1277.html
There is a thread about these bars around here somewhere.
http://www.khromewerks.com/SWEEPER-B...1029-1277.html
I just installed the Krome Werks 2 +2 Narrow Sweepers on my 2016 Street glide special to replace the Harley 2" pullbacks. I had the Harley 2" pullbacks on my previous two Ultras and they worked fine -- but not with the Rushmore faring and frame. They were two low and made me lean foward. The dealer could not raise them without bumping the frame. I have not not ridden much yet with the new bars but they are difinitely an improvement and I can use my backrest. I think Harley redesigned the Rushmore frame and fairing but not the pullback bars.
#220
I just installed the Krome Werks 2 +2 Narrow Sweepers on my 2016 Street glide special to replace the Harley 2" pullbacks. I had the Harley 2" pullbacks on my previous two Ultras and they worked fine -- but not with the Rushmore faring and frame. They were two low and made me lean foward. The dealer could not raise them without bumping the frame. I have not not ridden much yet with the new bars but they are difinitely an improvement and I can use my backrest. I think Harley redesigned the Rushmore frame and fairing but not the pullback bars.
The following users liked this post:
NLeischen (06-02-2016)