Installing 2" Pullback Bars FLHTK (Pics included)
#171
So I went and got my bike after having had the Kromewerks 2+2 bar put on. I was pretty disappointed when I sat on the bike because the bars were considerably higher but certainly no closer to me. I was reaching as bad as before but higher. It felt worse than original if anything. I rode the bike home and decided to angle them back. I used these pictures as a guide to disassemble the fairing and rotated the bars down and back, then rotated the grips as much as possible. I took the bike out for a ride after changing the angle and have a position that I can live with. Perhaps the sweeps would have been a better selection.
#172
All is well. I'm not unhappy with the dealer's service. I'm glad I had a chance to take the fairing cap off to see how it comes apart.
#173
#176
#177
#178
From what I can tell by looking at them side by side in the showroom; the bars are the same diameter. It is simply smaller grips (non heated).
#179
Hi JT HD,
I have the Khrome WerksŪ Part # 300077 2+2 bars and wanted to know if you think I need to change the brake or clutch hydraulic lines for these? I have used the 2" pull backs before on my last 2011 Limited and they were great but wanted a little higher as well. Thanks much for the outstanding write up. You ever thought about going to work for one of the motorcycle magazines?
Have a great day my friend,
Ken
I have the Khrome WerksŪ Part # 300077 2+2 bars and wanted to know if you think I need to change the brake or clutch hydraulic lines for these? I have used the 2" pull backs before on my last 2011 Limited and they were great but wanted a little higher as well. Thanks much for the outstanding write up. You ever thought about going to work for one of the motorcycle magazines?
Have a great day my friend,
Ken
#180
I cannot find this part number on the HD website. The search results are coming back with nothing. Is there supossed to be a dash somewhere in there?