Take in mind, from a cosmetic point of view only, the retaining bolt for these is smaller than the factory one. Can look kinda odd side by side on the bike.

Works just fine though.

 

This is an idea I wish I had thought of. OEM fitment, accomplishes what I want and helps out another rider with the same desire

 

That's the one I have also it sits just behind the floorboard si I can get my whole boot on the board.

 

Put Kury board relocators on my 03 and then the 12 when got it, Arthritis is a big complaint for old fuds as I so heel shifter stays, minor movement to shift and no hard pull up against ankle. Installed extended aluminum levers and not looked back with no issues against my size 14's.

 

If I wanted to convert my 07 FXSTC to a heel toe, what shaft would I need?

 

I put an extended SoftBrake heel shifter on my bike but it’s not rounded and “melted” like the Harley toe shift lever, so I took it off and bought these from Harley. Extended one inch in either direction. It does allow you to drop the heel shifter down lower than the standard heel shifter.

https://www.harley-davidson.com/us/e...ver/p/33600001