Highway Pegs for New Limited
#21
I also think they look nicer then the standard mounts most folks use. I also use them 2 ways using them as highway pegs and then occasionally for a change of foot placement I will leave my heels on the floorboards and then the ball of my foot on the highway pegs.
They are heavy duty and well made.
The following users liked this post:
Ciro3d (06-01-2018)
#22
I went with the LONG angled ones on my 15' Ultra Limited. With my 30" inseam the long's fit me better and allow me to either place my feet on the pegs or just rest my heels on the floorboards while my shoe's toes rest on the pegs. That gives me lots of foot movement and position changes.
#23
#25
Normally not a huge fan of Kuryakyn, but they got two things right: Iso Grips and these Offset Highway pegs. Absolutely love these pegs on my '15 Ultra Ltd.. They can be adjusted forward to give more leg room, or pulled back closer to the rider for shorter legs. Also can be adjusted higher or lower to the ground. Perfect fit for the lowers. Real solid and well constructed. Do a good online search for the best price, as prices vary quite a bit.
https://www.ebay.com/itm/Kuryakyn-Offset-Highway-Pegs-for-1-1-4-Engine-Guards-Tubing-7993/162556429946?epid=171260092&hash=item25d91e467a:g: ww4AAOSwMEtaYTIP
https://www.ebay.com/itm/Kuryakyn-Offset-Highway-Pegs-for-1-1-4-Engine-Guards-Tubing-7993/162556429946?epid=171260092&hash=item25d91e467a:g: ww4AAOSwMEtaYTIP
I agree with this! I have the offset pegs on my Limited and the ISO grips on my EVO. If my Limited did not have heated grips, I would have ISO grips on it as well.
#26
I just bought a set of the Kuryakyn premium mini floorboards. They are black powder coated to match my black highway bar. It doesn't seem like there's anyway that if I tighten them down to get the clamp fully closed that it's not going to deform the highway bar. They just don't seem big enough.
Anyone run into this issue?
Anyone run into this issue?
#27
I just bought a set of the Kuryakyn premium mini floorboards. They are black powder coated to match my black highway bar. It doesn't seem like there's anyway that if I tighten them down to get the clamp fully closed that it's not going to deform the highway bar. They just don't seem big enough.
Anyone run into this issue?
Anyone run into this issue?
#29
Thread
Thread Starter
Forum
Replies
Last Post