motion pro fork oil level tool?
#1
#2
#3
#5
The "tool" makes sure you have the same amount of oil in each tube.... I always overfill the tube by a oz or so, use the tool to suck out the over fill in each tube, this way I know they are at the same level.... Also a vice tube holder, works very well to keep the tube straight. Its an easy job, just do it right
Be Safe JIM
#6
Oil Gauge
I only use an oil gauge. You can get te exact tool on Flee-Bay cheaper w/free shipping. The company that Motion Pro uses to purchase seams to be the exact same company everyone else used to purchase, the only difference is the price. Both tubes do not have the exact same volume. I use a Wilton Vice with Sofjaws mounted to a 12" I beam welded to a plate and stand on the plate. Makes working on forks easier.
Trending Topics
#8
I used it on my other bikes. This is why I think they did not say how much oil. On my other bikes the left tube and right tube took different amounts of oil from each other. But they call for the same height from top of tube when filled. It was easier to over fill slightly then allow to settle and just suck out to desired level. One side was designed different so it have a different volume. Never did my Harley forks as of now.
#9
Courtesy Of KTM
There are a number of siphoning tools available from aftermarket manufacturers and suspension tuning services. If you do a lot of suspension work, these are worth the money. They vary in design and cost but they all achieve the same end result of setting the proper oil level.
With the fork tubes (or fork cartridge if applicable) collapsed and the fork spring removed, insert the metal tube into the fork leg with the plastic strap parallel to the top edge of the highest fork tube. If the oil level is lower than the tube's end pour in some oil to cover it. Squeeze the air out of the plastic bottle and release, the expanding plastic bottle should create enough vacuum to siphon out the fork oil to the tube's end. You're all set at that point; cheap, quick and easy.
There are a number of siphoning tools available from aftermarket manufacturers and suspension tuning services. If you do a lot of suspension work, these are worth the money. They vary in design and cost but they all achieve the same end result of setting the proper oil level.
- A clean empty plastic bottle. Most fork oil bottles work well.
- A piece of vent or fuel line with an ID of 1/4" (6mm). Clear works best.
- Straight metal tubing 8-10" (250mm) long with a 1/4 inch (6mm) OD and an ID as large as possible. Most hardware stores have copper tubing that works.
- A drill bit that's 1/32" larger than the OD of the vent hose you're using.
- A small plastic tie-wrap.
- A measuring tape.
With the fork tubes (or fork cartridge if applicable) collapsed and the fork spring removed, insert the metal tube into the fork leg with the plastic strap parallel to the top edge of the highest fork tube. If the oil level is lower than the tube's end pour in some oil to cover it. Squeeze the air out of the plastic bottle and release, the expanding plastic bottle should create enough vacuum to siphon out the fork oil to the tube's end. You're all set at that point; cheap, quick and easy.