Yet another exhust question, sorry
#21
I have a bone stock 2015 limited low, I would like to change slip ons but want something with a little rumble, just above stock. Any suggestions? If I decat header does it give very much more sound? Was looking at Rinehardt, if put on them and decat do I have to remap? Will that make it very loud?
I know this is to personal taste but would like a few suggestions, thanks for a great site.
I know this is to personal taste but would like a few suggestions, thanks for a great site.
Last edited by Bafflingbs; 10-10-2016 at 01:48 AM.
#22
October issue of Baggers Magazine has a great review of 30 pipes, Including some Dyno and Sound Level results on 12 of them.
I have to be honest, I didnt know that simply changing pipes could increase HP and Torque as much as it did in their results, though I guess at an increased sound level.
I have to be honest, I didnt know that simply changing pipes could increase HP and Torque as much as it did in their results, though I guess at an increased sound level.
Last edited by alarmdoug; 10-14-2016 at 10:44 AM.
#25
I put the CVO slip on I got from eBay, sounds good still thinking about removing cat to get rid of some heat.
If I remove cat and put K&N stock replacement filter will I need to go with a tuner?
The CVO mufflers was a good call look great, maybe need just a touch more sound, after a lot of reading sounds like cat removal will be the ticket.
Thanks to everyones help.
If I remove cat and put K&N stock replacement filter will I need to go with a tuner?
The CVO mufflers was a good call look great, maybe need just a touch more sound, after a lot of reading sounds like cat removal will be the ticket.
Thanks to everyones help.
The following users liked this post:
GalvTexGuy (12-25-2016)
#26
Which tuner?
I have the same set up minus tuner, which did you get and which tune, if you don't mind me asking
Thread
Thread Starter
Forum
Replies
Last Post
Leadfoot915
Touring Models
4
10-05-2014 07:46 AM