same here, ordered Wed got it Fri & installed today.
Works great just hit Hi or flash to pass and she opens.
Will be great now to not have to wait for her to remember the code, lol
*i posted after a quick install & still in garage. It might be how/where I have tx/rx wires but I need to be right on the door before it will activate
Last edited by Billman812; 09-01-2016 at 12:26 AM.
Reason: Clarify
Do any of you guys have any trouble shooting advice ?
I have mine hooked up, I have green light on the remote, red lights on the receiver and it will not activate the door.
Are you sure you are using the right screw terminals in the receiver? Terminal Block 1 from C (common) to NO (normally open). There is also a sync process in the instructions, didn't need to do that on mine, says they come pre-sync'd.
Are you sure you are using the right screw terminals in the receiver? Terminal Block 1 from C (common) to NO (normally open). There is also a sync process in the instructions, didn't need to do that on mine, says they come pre-sync'd.
I had the correct terminals, but evidently did not have the wires engaged properly. After reading your comments, I went out double checked the wire locations, took them out and re-inserted and abra cad abra , door works!!
I had the correct terminals, but evidently did not have the wires engaged properly. After reading your comments, I went out double checked the wire locations, took them out and re-inserted and abra cad abra , door works!!
Sweet! Glad it was something easy. Only used my for a couple days so far but I'm super loving it, what a nice convienience.