Just ordered Malo bars for the RGU..........
#11
#12
Super easy install and you don't need any extensions. Like others have said, you need to cut a couple of zip ties to free up some slack. The below video is really all you need to understand how to do it.
Take your time pulling the cables. I depinned the TBW connector like in the video and had no issues.
Go slow, put a towel over the gas tank, and get it done. I pulled the bars in about an hour on a Friday night, ran all the wires in about an hour the next morning and installed the bars in about an hour as I put everything together then found out my bars hit my Klockwerks shield at full stop, so had to pull them back a bit.
Take your time pulling the cables. I depinned the TBW connector like in the video and had no issues.
Go slow, put a towel over the gas tank, and get it done. I pulled the bars in about an hour on a Friday night, ran all the wires in about an hour the next morning and installed the bars in about an hour as I put everything together then found out my bars hit my Klockwerks shield at full stop, so had to pull them back a bit.
#13
bars are my next item for my 2016 RGU.
I like the HD Chizeled look.
really don't want to replace cables or add wire extensions.
but i would like to install heated grips.
Looking at 12" malos.
duckcomando
new bars installed yet??
rock103
why the poly bushings?
CR3999
why do you wish 12s now instead of 14s?
I like the HD Chizeled look.
really don't want to replace cables or add wire extensions.
but i would like to install heated grips.
Looking at 12" malos.
duckcomando
new bars installed yet??
rock103
why the poly bushings?
CR3999
why do you wish 12s now instead of 14s?
#15
#16
Thread
Thread Starter
Forum
Replies
Last Post