I do not see myself paying $800 for a set of the ugliest bars ever made for a bike. Not so sure I would put them on a kids tricycle let alone a Harley. I can not for the life of me see why they are the money they are asking.

 

Mine are basically 2 up 2 back. There is room to rotate them some. Mine keep my hands behind the fairing and I was able to install them without adding extensions or replacing any cables, just had to clip some zip ties behind the fairing and reroute a few things.

 

Thanks for all the feedback , looks like the 578's are a good choice for me

 

I'm also 5'7" with a 32" sleeve and I'm going with Khrome Werks 2+2 narrow sweepers.
2 up and 2 back

 

I had the HD pullback bars on my 12 Ultra and they were ok but I decided to go with Khrome Werks +2 Sweeper bars Narrow on my 14 Limited. I prefer the Khrome Werks bars.

 

I definitely like my Khrome Werks 2+2 Sweepers. I went with the wide ones. I have 2 guys in my HOG Chapter that want me to install them on their trikes now.

 

What he said. They fit me perfectly at 5' 6". My hands are between my shoulders and elbows and I can ride all day long on my '14 SGS. Make sure you order the NARROW 2+2's. And they're reasonably priced on top of not needing to extend any cables.

 

Having owned five trikes, last one a 14 TG, if I was going with 2+2 sweepers, I would go with the narrow ones unless they a very long armed, driving a trike and at full lock would a stretch with the wide ones...just my opinion...check on the TG forum...

 

Casper, I am looking at a Street Glide and pullback bar options. I had the Harley pullbacks on my Ultra, they were ok. I am 5'10" and a 34 arm length. Do the sweepers put the bars back about 2 inches from stock?

 

This is from the Khrome Werks site about the narrow 2+2 sweepers:


Features: By customer request - our popular 1" Sweeper handlebars are now available in a Narrow version. Grip to grip is 31-3/8"; three inches narrower than our current bagger Sweeper bars. Compared to the 2014 factory handlebar this bar provides 2-7/16" additional pullback and adds 2-11/16" in height. Grip angle is rotated slightly forward (3-1/2 degrees) for more comfort. Diamond knurls, elliptical center slot, drilled dimples with right grip notched for ETC. May be used on 1997-2007 models without ETC for internal wiring. See P/N 300100 for our ETC Grip Extension for non-ETC applications. NOTE: One piece upper riser clamp (H-D 55918-08) must be used when installing bars with center elliptical slot on pre-2008 baggers.


These may be the bars I need as well.