Stage 1 and warranty issues..denied?
#1
Stage 1 and warranty issues..denied?
Has anyone had an issue with their bike and being denied warranty work because a stage 1 was installed?
If so what was the outcome? Would the manufacture of the fuel system help fight them?
It would seem that adding a stage 1 would only make the bike run better.
Thanks
If so what was the outcome? Would the manufacture of the fuel system help fight them?
It would seem that adding a stage 1 would only make the bike run better.
Thanks
#2
If a problem is caused by the stage 1 and can be proven, then yes you're warranty is void only if you bought an aftermarket tuner or had it dynoed. Slim to nothing chance that it would be caused by the stage 1 unless it was a bad flash by an aftermarket tuner. If you had a dealer flash, you'd be covered but they're pretty much worthless.
#3
If they "the dealer" can prove that your "mod" caused the damage then, yes, they can deny that claim. Your warranty isn't a "one and done" contract. Its on a claim by claim basses.
If you do a stage 1 and your transmission goes out or a wheel bearing goes bad, then you're still covered.
But, if you did that stage 1 and you burn a hole in a piston then you'll probably have to pay for that our of your own pocket, but your "warranty" for everything else is still "good".
Unless your local dealers service department is being really pissy, then all bets are off.
Last edited by Rat Trap; 04-21-2015 at 10:18 PM.
#4
#5
Warranty: Installation of Screamin’ Eagle
® products, and similar offroad
or competition products from other manufacturers, except some
street-legal offerings installed by authorized Harley
® dealers, may void
your H-D
® limited vehicle warranty. See your dealer for more information
Last edited by Harttoo; 04-21-2015 at 08:51 PM.
#7
Trending Topics
#9
Well I am about to find out here real shortly. The dealer is almost here with a trailer to take it back and check the motor. They installed the Hi-Output mufflers, but I installed the Dresser Duals and added an FP3. I flashed back to the stock settings and took the FP3 off the bike. From everything I've been reading on here and how I explained it to the tech, I more than likely have a lifter issue. I have 2026 miles on the bike and hopefully this will be fixed quickly. First time dealing with a new vehicle and warranty issues.
#10