What's the trick to get the power vision cable disconnected from the power vision unit?

 

you will see a little push tab on back of wire connector , push it in and pull wire out of unit . you may need both hands.

 

Strange. Maybe it is because I have the PV2, but my cable has no tab. It just pops right out.

 

PUT YOUR GLASSES ON SO YOU CAN SEE THE RELEASE TAB im not yelling i just want you to be able to see this

 

I have my glass on but I still can't seem to push that little tab (I/16 to 1/8) on the back in right below where cable enters unit? Even tried a small screw driver to push in with. Last thing I want is to break it...

 

are you pushing on the right end of the lock tab?

 

Push down where I put a little orange paint on the tab. Look at the close up of the PV and you will see a little raised area the tab needs to clear to pull it back.

 

Mine does not have the tab either and it was purchased two months ago.

 

Thanks for taking the time & the great explaination...