They look good on your ride! Really like the names you gave your sleds!

 

From those photos in this thread, they look to be about the same height as Yaffee 12" Monkey bars. Definitely higher than my 10" PYO MBB's.

 

HD website really gives a good picture of them on a bike to see the height.

 

Off the Wall, do your bars have any pull back ?, i like the height , and what's the name, don't know the abb.

 

The bars are 10" black Paul Yaffe Original - Monkey Bagger Bars (PYO MBB's).

They have pull back. I'm not sure of the exact measurement. You can see the pull back pretty good in these photos.



10" black PYO MMB - side view



10" black PYO MMB - rear view

 

Thanks bro, they look good, going to go research now, tnx again

 

I'm looking into some apes too, I have long arms and bad wrists so I want something more straighter with little to no pull back.

 

2014 Ultra Limited


Ok guys I bought the 10" Wild One mini apes and I am DYI the process. The throttle cable and heated grip cables were long enough and of course the clutch and brake cable was long enough. The wires going on the outside of the stock handlebars to the switches are not long enough to be routed outside or inside the new bars.


I went to HD and they ordered the factory switch extensions which were the heated grip and throttle cable extensions. They ordered another set that looks correct in the photos Part # NHCX-J04 to J15. They look exactly like the original ones. Any Ideas?

 

I don't think so. I just did a set of 10 Yaffee Monkey Bagger Bars and the only thing I needed was these.

Switch Wire Extension Kit-69200034

http://www.kutterharleyonline.com/ha...ge_580440596=7

 

Thank you offthewall. I am officially an idiot. For some reason I had it stuck in my head the extension would tie into the handle switch. I didn't realize it is extended from the fairing side. Your pictures helped. How well did your heated grip module fit inside your bar. Mine is extremely tight and makes me uncomfortable forcing it in?