Engine codes
Thread Starter
|
Elite HDF Member
Joined: Jul 2007
Posts: 4,749
Likes: 16
From: sand mountain Alabama
Engine codes
I have a 07 Ultra
96 ci
Se 255 cams
V&H fuelpak
SE slip on's
V&H true duals
Se ac
I got engine codes
po132 front oxy. snesor high
po 152 rear oxy. sensor high
p1353 what ever that is.
The engine ling goes out as normal when cranking then it comes back on for around 8 seconds and the goes out again
any ideas
In God we Trust
dd
96 ci
Se 255 cams
V&H fuelpak
SE slip on's
V&H true duals
Se ac
I got engine codes
po132 front oxy. snesor high
po 152 rear oxy. sensor high
p1353 what ever that is.
The engine ling goes out as normal when cranking then it comes back on for around 8 seconds and the goes out again
any ideas
In God we Trust
dd
Seasoned HDF Member
Joined: Jun 2006
Posts: 28,577
Likes: 3,957
From: Vermont
P1353 = front cylinder no combustion. Check the plug wire to make sure it is tight on the plug. I usually get oxy sensor high codes after I run a long trip steady on the interstate. I usually just clear them and they don't come back until I take a long trip again.
Thread Starter
|
Elite HDF Member
Joined: Jul 2007
Posts: 4,749
Likes: 16
From: sand mountain Alabama
That's basically what I did. I cleared all the codes and check plugs for tightness and took a ride. came back and checked codes. They were none and the engine light has not come back on.
Thanks dawg that gives some peace of mind.
In God we Trust
dd
Thanks dawg that gives some peace of mind.
In God we Trust
dd
Thread
Thread Starter
Forum
Replies
Last Post
Bocifus
Ignition/Tuner/ECM/Fuel Injection
3
Jul 14, 2013 11:54 PM
