I like this one. Do you have it mounted to the controls, or on the bar? I'm thinking of using a bar clamp on the crash guard....
Mine is mounted on the left hand control clamp. I don't think i would want it near the motor area, to hot down there, plus I can reach it without looking away, safer. I'll try and snap a few pictures for you tomorrow
This is what I have. Works great, especially the swivel. I Chew so I use it for a 'toon. Could be a little deeper but never had a spill or bump-out. http://www.rammount.com/part/RAM-B-132BU
This... Best one out there. Once you have the ball mount you can attach all of their accessories to the same mount.
I have the Kruzer Kaddy mounted on the left...it's nice but wants to tip to the left/right with a full drink in it. Never an issue on my '10 SG but not craz about it with my '14 Limited.
I have the same problem. It becomes top heavy and tips with a full drink. It's annoying to say the least, but will only tip so far. I will buy something different next time.
From: Left Ohio for the middle of no where in Fla.
FWIW,
My 1st Kruser Kaddy swung around as described
When I got moved it to the new scoot, I found the 1" or spacer can be installed 2 ways.
Each end is machined different, the way it is now the holder doesn't move
I have the Kruzer Kaddy and also the HD phone mount. I made the clamp ring out of SS for my phone mount, then made the opt mount for the cup holder that can be removed from the clamp when I don't want the cup holder on. I wanted my cup to be behind the WS out of the wind and bug flight paths. Not one for a bunch of mounts only bars, thus the single slim clamp mount that holds both holders. Simple and clean
Not sure why it's sideways and can only attach1 pic at a time???
Just noticed if I clicked on the thumbnail to bring it to viewing size, then clicked on the pic again, it would make it full size and in correct orientation. Odd