starter wont engage.. just spins...

muleman · #1 09-13-2009, 03:39 PM

what would cause this.. should i just rebuild it, or by a aftermarket one like a ultima.. thanks..

This ad is not displayed to registered and logged-in members.
Register your free account today and become a member on HD Forums!

StrokedNBored · #2 09-13-2009, 03:48 PM

Check your battery to see if you have enough juice to engage the sprag clutch.

muleman · #3 09-13-2009, 03:50 PM

yea i did put it on a jumper and it just spun faster no engagement..

Mascman · #4 09-13-2009, 06:08 PM

Not sure if it will work, but put the bike in a high gear and try to move it a little...maybe the teeth just aren't catching right.

db252 · #5 09-13-2009, 07:25 PM

Your starter solenoid is shot. You don't need a new starter, just the solenoid but you'll have to take the starter out to do it and change out the solenoid with a new one from HD. Not that big of a deal....I'm on my second change.

dynamac · #6 09-13-2009, 08:55 PM

When that happened to me it ended up being a starter clutch. Cost $100 for the part. It was pretty simple to change out. Had to take the primary cover off and reservice it.

maddghost · #7 09-13-2009, 10:14 PM

Quote:

Originally Posted by dynamac

When that happened to me it ended up being a starter clutch. Cost $100 for the part. It was pretty simple to change out. Had to take the primary cover off and reservice it.

Ding ding ding!!! that is what happened to mine 1 month ago.at first it would skip a bit then engage and at the end just spinning, ++ the good news is the replacement part is an enhanced part so this should only happen once.

muleman · #8 09-14-2009, 12:29 AM

yea starter clutch is what Im thinking... i think i might by a ultima starter off ebay found one for 147.00 shipped and sell the stocker, so i dont have to mess with it and get a nice all chrome one to go back in... anybody think this would be a bad idea???

muleman · #9 09-14-2009, 12:32 AM

here's the listing....

http://cgi.ebay.com/ebaymotors/ULTIM...Q5fAccessories

muleman · #10 09-14-2009, 12:36 AM

Quote:

Originally Posted by db252

Your starter solenoid is shot. You don't need a new starter, just the solenoid but you'll have to take the starter out to do it and change out the solenoid with a new one from HD. Not that big of a deal....I'm on my second change.

i would think if it was the solenoid it would not even spin the starter.. just click. am i right?