You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join HDForums.com community today!
At least my dealer had not heard about the issue, I told them I had read on the net about the "conversion kit" and some failures, they called the headoffice and they confirmed that there has been some failures and that there is a "conversion kit", but to my knowledge there is no recall.
If there was no noise, what are the symptoms? \\;\\\\\\;
Thanks...
In my case I have an aftermarket speedometer. It does not have a "check engine" lamp. So I was not aware of the matter until the battery got flat. Just before the battery got flat, I had some backfiring. I guess this was due to that the low voltage got the ECM confused. So with OEM instruments I believe \\;one would have an DTC set, that make the check engine lamp lit, and also the low batt symbol to light prior to flat battery. \\;/Dan
I'm getting one of those Kuryakyn Informer Flush Mount Gas Guages with a battery volt / amp meter om it - should get an early warning that way if the thing starts to pack up.
__________________
'07 Pewter Denim Street Bob
Stage 1 & Kitech Fueler
V&H Big Radius pipes
Progressive rear shocks & fork springs