Clutch Removing/Installation
Thread Starter
|
Advanced
Joined: Jan 2008
Posts: 67
Likes: 0
From:
Clutch Removing/Installation
I have a 96 Fatboy....recently burnt the clutch out...I just got the primary off and gonna be tearing into it...It looks like I need a puller if anybody has a link too step by step directions on installation and removal I would appreciate it! Also I posted in softails section..Whats a good clutch too buy? I got a few responses Energy One and Barnett but just kinda looking for a few more opinions on a good clutch that will withstand a few burnouts since I like doing them...lol Thanks TrAmPTaXi
Road Master
Joined: Jul 2007
Posts: 1,009
Likes: 4
You don't need a puller. You will need the tool to compress the spring to remove the snap ring. With the snap ring out, remove the spring, pressure plate and spring compressor as a unit. Remove the steel and friction plates. Replace them with the Energy One extra plate kit. They sell a kit that comes with the spring compressor. $160
http://www.energyoneclutches.com/home.php?cat=9
http://www.energyoneclutches.com/home.php?cat=9
Thread Starter
|
Advanced
Joined: Jan 2008
Posts: 67
Likes: 0
From:
You don't need a puller. You will need the tool to compress the spring to remove the snap ring. With the snap ring out, remove the spring, pressure plate and spring compressor as a unit. Remove the steel and friction plates. Replace them with the Energy One extra plate kit. They sell a kit that comes with the spring compressor. $160
http://www.energyoneclutches.com/home.php?cat=9
http://www.energyoneclutches.com/home.php?cat=9
Thread
Thread Starter
Forum
Replies
Last Post
notofthisworld
Primary/Transmission/Driveline/Clutch
1
Dec 25, 2012 03:42 PM
