07 FXDC Fork Tube Caps - Size?

Reply Subscribe

Thread Tools

Search this Thread

Oct 13, 2009 | 05:47 PM

2007fxdc

Thread Starter

Elite HDF Member

Joined: Aug 2007

Posts: 4,722

Likes: 7

07 FXDC Fork Tube Caps - Size?

Was able to squeeze in enough time today to install my new chrome sliders but haven't refilled the tubes with fork oil yet. Mainly because none of my sockets fit. My 1 1/2" socket is too big and the next size down in my set is too small. Anyone know the size? I'd prefer to do this with a socket wrench so I can keep pressure on the cap so it doesn't go flying when it comes loose. I also don't want to try to wrench it with pliers or something adjustable because I don't want to scratch the caps. If I know the socket size, I will go buy one. I don't see any mention of the actual size in the service manual.

Otherwise, does anyone have a method they could recommend for going about this with different tools but without a second pair of hands? I am planning on covering my tins to keep something from getting away and scratching or denting them.

Oct 13, 2009 | 06:31 PM

thedonthere

Outstanding HDF Member

Joined: Dec 2008

Posts: 2,419

Likes: 1

From: Ashland Ore.

Try 36mm.Everything to do with the forks is metric as they are Showa forks.

Oct 13, 2009 | 06:43 PM

jmpancoast

Outstanding HDF Member

Joined: Jan 2007

Posts: 3,438

Likes: 3

From: Chesterfield, VA

If you don't have metric that big, 1 3/8" should work.

Oct 13, 2009 | 08:11 PM

bberck

Elite HDF Member

Joined: May 2008

Posts: 4,579

Likes: 10

From: S.E. MO

Quote:

Originally Posted by thedonthere

Try 36mm.Everything to do with the forks is metric as they are Showa forks.

+1

36MM on my 08

Oct 14, 2009 | 07:35 AM

billyboy890

Extreme HDF Member

Joined: Oct 2007

Posts: 16,932

Likes: 0

From: north yorkshire

the guys are right,just stripped mine,36mm or 1'3/8''

Oct 14, 2009 | 10:39 AM

SC-Longhair

Club Member

Joined: Feb 2008

Posts: 11,483

Likes: 39

From: Passaic County, NJ

it's 35mm...not 36mm. 1 3/8"

Oct 14, 2009 | 12:00 PM

2007fxdc

Thread Starter

Elite HDF Member

Joined: Aug 2007

Posts: 4,722

Likes: 7

Quote:

Originally Posted by SC-Longhair

it's 35mm...not 36mm. 1 3/8"

Figures I'd see this 5 minutes after getting back from going to 3 different stores before I finally found a 36mm socket and had to buy a 1/2" to 3/4" drive adapter as well. The good news is, the 36mm was close enough to get the caps broken loose. But I could tell there was a little too much play. Going out in a bit to finish this job.

Thanks all.