When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
It could be many of these ideas, but I would bet on the rings because of the age of the bike. If the rings are worn then on the compression stroke a little fuel would be forced past the rings into the crankcase.
Yeah but blowby will usually get burned off and only leave microscopic traces of fuel because it occurs while theengine and oilis hot. This guy can actually smell gas in the oil which means he has some serious dilution going on.I had a brand new Sportster that would leak fuel into the oil if you didn't close the fuel shut off valve. Turned out the valve was defective. So, my guess this guyhas a bad fuel shut off valve. Ifthe bikestarts and runs wellI would replace the fuel shut off valve and start using it all the time and just do a few carb cleanings to see if that is the issue.
It could be many of these ideas, but I would bet on the rings because of the age of the bike. If the rings are worn then on the compression stroke a little fuel would be forced past the rings into the crankcase.
Yeah but blowby will usually get burned offand only leave microscopic traces of fuel because it occurs while theengine and oilis hot. This guy can actually smell gas in the oil which means he has some serious dilution going on.I had a brand new Sportster that would leak fuel into the oil if you didn't close the fuel shut off valve. Turned out the valve was defective. So, my guess this guyhas a bad fuel shut off valve. Ifthe bikestarts and runs wellI would replace the fuel shut off valve and start using it all the time and just do a few carb cleanings to see if that is the issue.
I am not trying to be all knowing on the subject, but doesn't the blowby happen on the compression stroke when the fuel mix gets compressed in the combustion chamber, it will blow by the rings into the crank case? It can't get burned off in the crankcase. Now if the oil from the crank case was blowing by the rings into the combustion chamber, then yeah it would burn off. But you would probably have a lot carbon build up in thecombustion chamber.
Just my thoughts while being fully marinated, but someone teach me something when I wake up.
I am going to change the oil and filter I am going to use 20w 50 pennzoil in the 84 ironhead just don't want to waste new oil then I am going to put 20w50 harley for NJ weather again to get the rest of it out.I am going to check the petcock by diconnecting the fuel line to see if that is good. I am going to take the air cleaner off the s&s carb and take a look at the carb and the diaphram, needle and seat. just visual, is there going to be anything obvious that I will notice that might be bad? Thanks Charly
I have a s&s carb. Does the oil change color Also can the bike get flooded and eventually get blow by. the bike seems to run good. Is there any other test I can do I don't know much about the S&s carb Thanks again charly
A quick way to see what's going in the cumbustion chamber is to read the spark plugs. If they are black, the engine is running rich. If they are a wetish black, use your sense of smell...it could be wet with gas or oil. Those ironheads are notorious for running dirty what with the full hemispherical cumbustion chamber and domed pistons. Watch for black smoke in your exhaust.....that is a sign of running rich.
You are right. I am going to do that when I get home. I just went to the dealer to get a new oil filter. I also asked his opinion and he said those bike had those problems and he said change the oil and see if the smell comes back.
Now the needle in the S&S carb is under the diaghram. Now the seats are located where in the carb Thanks
I'm not sure I understand your statement, but there is no diaphram or needle in an S&S carb. If you are refering to the float needle valve, it is at the topabove the float bowl held by the float assembly, the cooresponding seat is screwed into the carb body at the fuel inlet.
I am not familiar with the S&S carb I have stosk carb on my98 fxd. So the carbs are different. Can you explain if this can happen that gas can get into the oil Thanks Charly
It could be many of these ideas, but I would bet on the rings because of the age of the bike. If the rings are worn then on the compression stroke a little fuel would be forced past the rings into the crankcase.
Yeah but blowby will usually get burned offand only leave microscopic traces of fuel because it occurs while theengine and oilis hot. This guy can actually smell gas in the oil which means he has some serious dilution going on.I had a brand new Sportster that would leak fuel into the oil if you didn't close the fuel shut off valve. Turned out the valve was defective. So, my guess this guyhas a bad fuel shut off valve. Ifthe bikestarts and runs wellI would replace the fuel shut off valve and start using it all the time and just do a few carb cleanings to see if that is the issue.
I am not trying to be all knowing on the subject, but doesn't the blowby happen on the compression stroke when the fuel mix gets compressed in the combustion chamber, it will blow by the rings into the crank case? It can't get burned off in the crankcase. Now if the oil from the crank case was blowing by the rings into the combustion chamber, then yeah it would burn off. But you would probably have a lot carbon build up in thecombustion chamber.
Just my thoughts while being fully marinated, but someone teach me something when I wake up.
The fuel will get evaporated (burned off if you will) in the crankcase when the oil gets hot leaving only corrosive elements of the gasoline that don't evaporate but they are in all engines and don't smell like gasoline. These combustion byproducts are a big part of what turns your oil black with use.If this bike had so much blowby past the rings that unburned gasoline is making it past there in enough quantity then his performance would be horrible and the bike would smoke like a chimney. I could be wrong but I think he has a fuel leak somewhere. I had the same issue with my sportster. The oil stunk like gas. That is how I noticed it when changing my oil.
HD Forum Stories
The Best of Harley-Davidson for Lifelong Riders
Jason Momoa Is Turning Classic Harleys Into PHEVs
Verdad Gallardo
Harley-Davidson Fat Boy Becomes a Dark, Decepticon-Inspired Custom
Verdad Gallardo
6 Weirdest Harley-Davidsons Ever Sold to the Public
Verdad Gallardo
7 Times Harley-Davidson Chucked Tradition Out the Window
Verdad Gallardo
7 Surprising Harley-Davidson Products that Are Not Motorcycles
Verdad Gallardo
8 Best Harley-Davidson Motorcycles Ever
Pouria Savadkouei
10 Worst Harley-Davidson Motorcycles Ever
Pouria Savadkouei
Killer Custom's Jail Break Is The Breakout That Refused to Blend In
Verdad Gallardo
Crazy Bunderbike Build Looks Amazing, But Is It Impossible to Ride?
Verdad Gallardo
Harley-Davidson Reveals Super Cool Cafe Racer Concept
I am going to change the oil and filter I am going to use 20w 50 pennzoil in the 84 ironhead just don't want to waste new oil then I am going to put 20w50 harley for NJ weather again to get the rest of it out.I am going to check the petcock by diconnecting the fuel line to see if that is good. I am going to take the air cleaner off the s&s carb and take a look at the carb and the diaphram, needle and seat. just visual, is there going to be anything obvious that I will notice that might be bad? Thanks Charly
I'll bet if you disassemble and clean the fuel petcock and use it all the time to shut the gas off when the engine is off......then run some gumout through your fuel system you issue will be solved. One question: Has this bike been stored without fuel stabilizer in the gas? If so, it may just have some varnish on the carb internals.
Thanks kb giving me the time and hopefully it is something simple and explaining to me how it works. I will add cleaner and check the petcock. Thanks Charly also the bike did sit around but for how long i don"t know
Slideshow: Jason Momoa's latest restoration project blends 1920s Harley-Davidsons with modern electric technology, creating some of the most unusual hybrid motorcycles ever built.
Harley-Davidson Fat Boy Becomes a Dark, Decepticon-Inspired Custom
Slideshow: Killer Custom's latest build relies on styling changes rather than performance upgrades, giving the cruiser an entirely different personality.
7 Surprising Harley-Davidson Products that Are Not Motorcycles
Slideshow: The bar-and-shield logo shows up on far more than motorcycles, some of the company's most unexpected products have nothing to do with riding.
Slideshow: From the troubled AMF years to modern misfires, these bikes earned reputations for reliability issues, questionable engineering, or disappointing performance.
Crazy Bunderbike Build Looks Amazing, But Is It Impossible to Ride?
Slideshow: The Swiss custom shop has taken a Harley Softail and stretched it into something so long and low that it looks closer to a rolling sculpture than a conventional motorcycle.